Satisfied Customer of Super Stackers

Подписаться 98

Просмотров 31 тыс.

50% 1

Hear from Bobby Thomas about the Super Stacker Door Finishing System and how it will revolutionize the way you finish your doors. Whether you paint, stain, and/or clear coat your doors. The only way to do them is with the Super Stackers Door Finishing System!

Хобби

Опубликовано:

9 фев 2014

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 16

@SuprMommy1 10 лет назад

I'm impressed that you can actually get your customers to do this for you. Takes a great product for folks to go out and endorse it for you. :D Good Work!

@1966johnnywayne 4 года назад

There is no need to flip the door when setting it on the floor...just be consistent when you start...either nubs up or nubs down and they'll all end the same.

@macbook12345 5 лет назад

The only challenge I see is that you need two people. And secondly, there is less air flow between the doors. Personally if I was shooting these doors Id stack them one at a time on the floor spray flip then place the next one and keep spraying the door on the top. That would cut the move time in half. Of course, you need to be mindful of over spray and build up on edges.

@corysimo9527 8 лет назад

as long as doors are the same height I think it may be OK. I could see warping issues if left too long. I personally like to leave them standing in a zig zag pattern.

@risepainting395 7 лет назад

That's what has had me leary. A lot of the doors I finish are solid core and the weight of them sitting horizontal while curing would be tremendous. The last set of doors were Sapele, and cost a pretty penny. Finished with clear lacquer and looked Gorgeous! I wonder about warping and bowing...

@corysimo9527 7 лет назад

Rise Painting if you seal the tops and bottoms beforehand it would help a little I'm sure but that weight. I think I'll stick to what I know.

@MegaKB33 5 лет назад

I always had done them the zig zag upright way too.But i helped a friend who had the super stackers and i have to say it was a hell of a lot easier and took up less room.

@magicmike6961 5 лет назад

Sammy Hagar's long lost twin brother?

@anouarsigale946 7 лет назад

Greetings to you. I liked Trivtkm dyeing doors. . . I hope you show me the way to buy and where it does exist in France, although there was Vorjawa you give me the address or anything that shows them to buy them. Thank you.

@heritagevalleypropaintingl7911 8 лет назад

Take my money.. My other ones suck

@DavidGarcia-pc1og 7 лет назад

Not bad but you will get to much overspray on your painted doors in the floor since your are inclosed.

@1821Luis 7 лет назад

That's correct.

@southsideshenanigans 6 лет назад

No he won’t. Theres not overspray anywhere near the racked doors. The fallout may reach that far with a really worn tip. Overspray is overspray not fall out. And fall out would really be the only concern. It’s not even really a concern in this case because the doors aren’t even close to being dry therefore no flashing from overspray or fall out etc. this is a good system. I have seen much worse methods work without flashing. this is something I’m gonna try next time I have to do a ton of doors.