Sam Villa ArTeam Member @rogermolinahair does it again with this #shaggy mullet Origami timelapse.
"Technical breakdown.
•
Face frame.
Diagonal section from recession to top of ear. Elevate forward and diagonal and cut blunt with diagonal finger angle. 10” long
•
Fringe.
Left side part, use a round line and cut rounded cut line from short to long, starting around 5-6” long
•
Sides
Elevate diagonal using a guide from the fringe at part. Cut flat with floor should be 7” ish. I measured with a tape measure. But a comb works
Top
Elevate top and crown to part line at fringe and end at center back. cut a slight diagonal line, leaving slight increase in length at the back.
Back.
Elevate diagonally and cut inside the fingers(razor style) using the length at bottom crown as your guide.
Perimeter
Over direct forward length to the guide at the back of the ear(face frame). Cutting razor style again connect length at perimeter at center back. Makes a V.
Balayage
Grab the longest length and rouge up to “tease” hair away. paint thick at the ends. With a dry gloved Finger, blend up to lighten saturation( less lift)
Keeps the ends wet!
This one was a lot of fun. I hope you enjoyed
Tool mentions
@samvillahair slicing shear, long comb and dry cutting clips." - @rogermolinahair
#SamVilla
#SamVillaCommunity
5 сен 2024
