Fascinating, (especially to the boy in blue, at 0:49 (if it's his son, well then we understand- "Dad is SO boring." LOL. But really this is a well narrated and informative video. Thank you, a lot!
Great video! I would humbly suggest that the words on the machine would say "16 gauge or THINNER" instead of "less". Some may misunderstand that as a "less" gauge; as in 10 gauge is a "lesser gauge" than 16. Which is obviously not what you meant nor is it common sense. But I've seen many people with less common sense. "16 gauge MAXIMUM" would work too! I had to do a double take when I ready that lol. But then again, I'm also just a slow learner :) Just my 2 cents. In any case, thank you for sharing!
I work at a sheet metal place and I was roll forming some 2*4 and I cut my thumb to the bone completely cut the tendon and cut a nerve pretty bad wear gloves
Ukazovat učňům jak ustříhnout několik kusů tenkého plechu , hrůza . To spouštění stroje by mělo jít do muzea a celý stroj s ním.Vůbec tam není zadní doraz,zbytky plechu nosí učitel přes celou dílnu!Chtěl bych ho vidět jak stříhá 1000 kusů rozměru 1x100x1000 z formátu 1x1000x2000. Vzadu za strojem se musí nastříhané kusy samy rovnat a vůbec nepřipadá v úvahu aby tam někdo stál.