Sig MCX Virtus PCP - Accuracy Problem Solved? 

what most people here dont realise is this is semi auto so your accuracy is also judged on your ability to pull the trigger without movement of the scope (even a little)

Best fittings do silencer adaptor for them if any one who wonts one in uk

yer killing me !!! zero the assembly !!!! please !!!!(it's shooting low right fyi)

Thank God I haven't bought one yet! But to mabey help. Maybe you need to shoot very light 22cal pellets. 12grn, or less. This is only sub 12ft pounds after all. I most certainly wouldn't dream of anything over 14 grn. Call SIG. Ask them what it's made to shoot. After all, they made it. ....Good luck and God bless you.

I can't tell you if you were speeding up the shooting process in editing or if you were really shooting that fast. This gun is regulated and to take full advantage of that(shot to shot consistency) I recommend shooting no faster than about one round every 5 seconds for the regulator to recover. Both German manufacturers make flat nosed/wadcutter pellets btw. There are folks on Ebay selling pellet seaters for this gun that will do more than one at a time.

The mags on these are the same as the Co2 MPX and they shot flat heads the best, might be worth a try

Were not expecting any PCP hunting/target rifle accuracy from this one to begin with. But, yes. Seating the pellets well probably is the best thing to do on this PCP version also (just by guessing that the internals may be somewhat based upon the co2 version). Own a co2 MCX and like very much to shoot it. Yeah - it has been a bit troublesome airgun, but I still like it. Have had it opened for fixing many times. Expect to need to fix something on this one also - whenever I finally get my hamds on one.. My MCX shoots a bit hotter from original nowadays, so the groups tend to look like columns because of hits dropping lower after the co2 cools down. 1" wide groups from 15 meters before power starts dropping is though good enough for me. Would just like more power consistency provided by a PCP system. But I guess it takes some time before the rifle reaches my airgun store this spring/summer..

It a suppression rifle for fast response rifle not a target rifle that is why it was made by Sig for training

I've been been hyped for this gun for a long time, but now thanks to your very informative testing you've shown me that it is in fact garbage. Thankyou so much for saving me from spending £500 on this piece of junk :).

Good follow up video Evan. Thank you

I really believe I can put pellets in a slingshot and do this well at 12 yards!......SIG would definitely be getting a phone call from me.

putting different weight pellets into a single belt is not an accurate test. your irons or optic zero is for a single weight at a certain range. I struggle to believe you are using hold point to account for the weight differentials. If you shoot a heavier pellet following a lighter one it will lower the POI (point of impact). I have a Virtus and it is not the most accurate however they are fun. try shooting empty shotgun shells at 10 yards it is epic fun :)

My bsa r10 loves those sniper magnums...... if you can find them

I'm dying while I wait to get my Virtus back. Very informative video though. Thanks

Diabolo: Pronounced Dee---ahhhh----bullo, ......not Die-ah-bowlow.

I just bought one of these. I hope it don't have any problems. This is my first pcp gun.... Can I fill the tank if it's attached to the gun? Or will that mess the seals up?

3/16 drill bit clears excessive drag from the magazine. Use a drill press for accuracy. Be sure to clean it. Barrel shipping grease can be an issue.

did you ever find any better ammo?

Does the H&N Sniper Magnum fit snug in the rail type magazine of the Sig? The JSB RS 13 gr and Diobolo 15 gr were loose and would pop out at times.

Im wondering what the crown on the muzzle looks like? if that useless brake is removable or not?? If so some accuracy could be attainable by simply redoing the crown and adding a good functional air stripper !!plz lmk what your thoughts are on this !!

I sent my brand new Virtus back since it grouped about 6 inches at twenty yds, The bore was filthy right out of the box and had rust in it, after shooting around 60 JSB 18.13gr the trigger and loading mechanism jammed! Very disappointing Sig...............

Does yours have some play in the stock/tank?

Would you sell......

best advice, must clean barrel after every 100 shots put bout 7 q-tips in barrel make absolutely sure no pellets in mag and while the mag is out temporarily push down the qtips until they reach the beginning of the barrel. Look inside gun make sure the qtips dont enter the nozzle. from inside the mag holder push the qtip with your finger (safety on) or bottle removed and push back the qtip inside the the barrel flush so that the mag can engaged when you put it back it. put the empty mag in and shoot twice in a safe directions and blow out the qtips. Next tighten the barrel screw on the tip of the barrel by removing the fake flash supressor use 11 mm open wrench tighten nicely but dont over tighten (caution first) make sure gun is empty first so remove mag when doing this part. sometimes this barrel screw gets loose or comes loose so tighten nicely which will compress the plastic holder that holds the barrel.this will make the barrel stiffer. replace reg on bottle to 1500 psi and remove spring inside black funnel tube to a paintball spring. After that you should get at least 17-18 fpe .nice power and decent accuracy Good luck get saved by accepting Jesus Christ repent and get Baptized before its too late. Seating the pellets will reduced annoying excess trigger pull and improve accuracy

Its pronounced dee-ab-e-loh.