Silverado custom door popper🔥😲 

Nice . I did something similar on my obs but with corvette style pocket door handles and a rubber trunk switch from a scion. I used a pulse moldule from ebay to only apply a half second of 12v to the actuator so you dont wesr them out by someone holding the switch too long (they will hold the switch down while pulling open the door). Next i used a Hella latching relay to power the switches only when unlocked. The hella latching relay as 2 ground triggers one to set and one to reset. They only.use current when making thay quick change from set to reset/ vice versa. So they dont use up any current when not locking /unlocking the alarm. Since the alarm has ground lock/arm and unlock/disarm i just fed them to thw latching relay so arm cuts 12v to my scion switches and disarm allows them to olerate/open doors. Im actually about to modify this setup with more hella latching relays so that when the truck is armed, pressing the door release switch will set off the alarm by sending a signal to the door pin switch of the alar. Either that, or it will honk the horn everytime a thief etc teies opening the door with that switch. Just some ideas from a fellow modifier!

Nice work bud!

Definitely putting this on my gen 1 s10 blazer, this is awesome!

That’s clean I need to do this to mine

Thanks for sharing nice job

what motion sensor switches are you using ?m

On your cluster you know how when you start it up with the dr 1 fob it says driver 1 is their a way to make it say something you choose when you start the truck like in the tbss and corvette on the gmt-800s

How did you wire or what sensor can I bay to open with the feet

How did you wire up the actuators? Same as if its being used as a power door lock conversion with two relays?

W