Every get it to work properly? I have an ap44, high capacity pump and a their compass. Waiting to put it on but keep hearing they dont stay on course and disconnect....
Hi, I see you have a tile on the home page of your MFD for the autopilot that allows you to have full screen rather than just the side bar for Autopilot control. How do you get this to happen. I have an NSS Evo3s with an AP44 and both have the latest software updates.
My simrad Evo3 in the autopilot section does not have the installation option. Just chart compass, auto hide bar, commissioning and steering response. I also can’t do anything after calibrating the compass.
Autopilot installed and working using your video. Only issue I'm having is I don't see an autopilot option on the home screen of my evo3. I can work control it through the side bar pop out but without the icon I can't build a multi-page with a section dedicated to the autopilot. How do I go about adding that icon?
Hi, I have the AP44, Nac2 Precision 9 package on a 29 ft boat. When I set it on Auto, it always needs to apply rudder to port, so there is the red line on the top of the heading. Manual is hard to understand, do you have any suggestions as to what settings I need to change?
I get the the "hold port" part. It takes a little wile for the engine to start turning to port but it does, then I let go at full port & then it says centering rudder but it doesn't center it, it basically turns almost to full stbd. Doing something wrong?
If you have not done the earlier steps correctly then it might do this. Please get in touch with us via FB so we can direct you to the correct service team.
@@simrad-yachting i actually got the autopilot to work. I just had to move the wheel a tad when it reached full port & starboard. Now im having issues with the wr10 wireless remote. Sent a message on FB. Awaiting a aresponce
Hi , Please advise my auto - pilot model AC-70 control what problem is this ... When navigation switch ON auto pilot start as ''Auto'' and not able to change ''Stand by''.
Hi Hari, the AC70 is autopilot computer, what kind of autopilot controller do you have? What plotter? We'll need to have more info on the rest of the network to be able to diagnose. Please send us the NIF file. You may also contact us via Facebook.
For the Simrad Auto Pilot setup, can it be operated via the integrated NSS Evo3S MFD and not through a separate Operator Control Panel? I don’t want to cut another hole in the dash panel if I don’t have to. Cameron
@@simrad-yachting Thank you. What are the benefits then of a separate AP controller (like AP44 or AP48) added into the NMEA 2000 interface that drives the autopilot tasks instead of directly through the MFDs? Cameron
@@simrad-yachting Thank you!. But are there differences in the software as well? Can I use the NAC-1 with a planing boat, and control it using VFR in both high and low speed?
You will not be able to control the Simrad autopilot from your Garmin unit. You will be able to get it to follow a route, but they will not be fully integrated.
Thank you for your message. We will be happy to help. We would need you to write an email to Simrad.tech@navico.com sending in your unit’s serial number. You will then receive an autoreply with a reference number starting with CA…. please send it to us so we can follow up on your case. Looking forward to your reply.
I just recently purchased a Grady White 330 Express, fully equipped with Simrad electronics. Already I'm looking to pull everything out and replace with Garmin. Simrad is way too difficult to learn and much needed time is required. Not user friendly at all!