SKIDOO REV MXZ 550f | EP04 | Replacing the rubber carb intake boots 

Thanks Phyllis.. In the new intro I think Mark was getting ready to give Brad a big hug but them he seen the camera 😂🤣 Won’t be long now ❄❄

Absolutely.. Nothing in the way and it’s nice to have a hood that actually opens instead of having to remove it. 🥴

😂 I hear ya buddy.. I've always called them carb boots.. But Skidoo calls them Carb Sockets so that's what I was calling them for the video 🤷🏼‍♂

Hey Paiste.. Next on the list are those rubber side panel latches, upper, lower control arm bushings, front shocks and chanincase fluid change👍🏼

@@SometimeIsNow Awesome! That sled is going to be very reliable when you're done with it.

@@Paisteboy it has to be else he won’t ride with me (wife) 😂

@@bunnydoo8426 That makes sence. Nothing worse than a breakdown on the trail.

Hey Chris, Thanks for stopping by the channel to watch the video. I do not have a video removing the oil tank. I believe by removing the air box & carbs you might get at the fuel pump that way. I myself would try that first with a set of long angled needle nose pliers for the hose clamps and fuel hoses before going as far as removing the fuel tank and oil tank.. Take Care and good luck. 👍🏼

Thanks! much appreciated. One more question, whats the best way to remove the crimp on fuel line clamps?@@SometimeIsNow

​@@chrisamadon279 Depending on which clamps, you’ll need either a pair of flat nose pliers or a small screwdriver for the ones inside the fuel tank . 👍🏼

Hey Big Murph, Thanks for stopping by to check out the video. It's appreciated. The little torque screwdriver is a Snap-on ATECHMS80FK Its is a nice little torque wrench for smaller screws. Take Care 👍🏼 shop.snapon.com/product/TechAngle-Electronic-Torque-Screwdriver/1-4%22-Hex-Electronic-Screwdriver-Kit/ATECHMS80FK

@@SometimeIsNow thanks I will check it out when the snap-on guy stops by the shop.