Thanks this will be so useful to me. Yesterday evening a BMW hit and run (drove off) into me. My driver's side wing wheel arch is dented in now. So I'll be removing the wheel liner so I can get in behind the wing with a panel beating hammer hopefully, as I don't have access to a pin puller at work or at home.
Yeh mam at -4.49 you circlenear the rocker panel seal , is it use for opening of rocker panel so we can use it for bends by inserting rods in middle of panel for remove dents? , Please help me.
Thanks. That is meaty enought for me. There is something that we say in my country that in English is something like: "grain by grain the chicken fills her belly."
@@HatBoyHarvey Thanks Harvey I will try from underneath, as soon as I do the coolant change I will try, as the colour of the coolant is green I bet somebody used an other coolant than the specified one
Hello Harvey! I am your subscriber from Russia. Do you have mud flaps in the UK or not? Otherwise I have them on my car, and I don't really understand how they should stand
That often happens, I'm told. Run the CD through all the tracks to the end and press next/forward eject, one of them, if no joy run to beginning/then end agian. also you could try inserting a long sticky label, push in onto CD with somthing very flat and see if you can pull it out and as a last resort pull the unit out a bit and gingerly tap the sides/bottom a bit whilst ejecting etc. Good luck, hope these work :-)
I have a fabia and I have a problem with the shock absorbers, I installed new ones, after this the fabia is very high from the front. I would like to know which floor height your fabia has. please measure with a tape measure from the floor to the vehicle body@@HatBoyHarvey
Hi Harvey! Great video again. My Fabia has this problem I am driving and sudenly heating turns on by itself. Everything is turned off but heat is coming out of the heater. Do you know why?
Thanks. It is most probably the flapper motor stuck on hot. move the lever from hot to cold to hot to cold a number of times as this overides the control and signals to move the flap. try this a number of times. getting to flap is hard and replacing needs obd to reset. Clean the cabin temp sensor behind the control cover on the right. Hope this helps :-)