Wow, that looks deadly! I think the PDP low pro led brake light would look great on there. A lime seat bracket and the 2017 LE lime seat cover would really finish it off.
I really like it. Has lots of support down the sides of the tunnel while still being light weight. Also the back part angles up so it is easy to grab the bumper and lift the end of the sled even if you are wearing gloves and the back end is trenched down and stuck or something.
Have you added coolant and tested for leaks yet? I tried the same kit on my sled, followed instructions to a T, and still had leaks. I noticed your inserts were very tight, as were mine, and I think that may have displaced the epoxy causing the leak!
I have one on mine. It started seeping last week. Cr racing in Canada is modifying their aluminum cooler to fit my sled for me and then I’ll have it welded in place. I’m not looking forward to pulling the mtntk crossover out and cleaning up all the epoxy. 😬
I ended up cutting an additional inch off just below the inserts and I throw the mtntk kit in the garbage! Found a local shop to weld the old crossover piece back In for me, good as new now
@@danp9164 that's pretty much what I'm doing. I don't have the old crossover as I bought the sled used so I'm having a part fabricated and then it will be welded in place. I don't want to have to worry about it leaking again in a year or two.
How is it been working? Any leaks or problems with this set? Wondering to order this.. my 146" sks would look sick with this 😍 and also behave little different 😎
Total length is 31 inches. However as you can see the front end of the bumper goes under the back of the running board by 5 inches. So it is only 26 inches from the back of the running board to the back of the bumper.
