Smart Home Part 7 Video 

I am remodeling my home. All your videos give me everything I need to wire cable TV, antena, networking, phone in entire house. Thank you so much!

Hi Ron, I have watched all your smart home series but was wondering if you had any videos on the IR modules that maybe used in these systems and how they might work?

Ron, my parents remodeled their home, and ran all the wires to future-proof the house, I was wondering where I could buy the cable management box and the amplifying splitter you show here. I went to the website, but I had no luck finding the product.

HI Ron, can you tell me were i can buy your amp/spliter? how much do they normally run? And one more can i use the two (amp/spliter and if i need more runs use a spliter ?) I have 12 runs right now and i want to bundle them all nicely in your low voltage panel. Thanks for your time and help.

Hi Ron Thanks once again for your help. What Do you think about these two amp/splitters i found on Amazon. one is from Viewsonics VSMA-608C and the other is PCT BooWDR94U both are around $50. and both have high comments the only bad i read is it gets warm to the touch. Thanks for your time.

Hello Ron, I've watched several of your videos and searched other videos but cannot find an answer to my question. Would there be any issues with running an 8-port splitter from the drop line and having the cable modem connected to one of the 8 ports? Someone told me an amplified splitter would interfere with a cable modem so I had to run a 2-way from the drop then connect (one to cable and one to the 8-way) Thoughts? Thanks

Hi Ron, I am enjoying your videos, but can seem to find an answer to my question. I have an antenna in my attic that runs to a amp/splitter in my basement then out to 4 TVs in my house. The run to my bedroom goes out to the garage and back into the house on the opposite side of the room from my TV. The result is a coax cable running along my floor. If I place a two way splitter in the attic, I can go directly to the bedroom on the wall with the two and the other run to the amp/splitter. What are your thoughts on this? Will I lose too much signal doing this? I am less than 15 miles from all tv stations that I care about.

Hi Ron, I am planning to buy 12 output. But only have 45~1000Mhz. Wil this still work? I mean, signal coming in will still be the same? What can you advise? Thanks.

Hi Ron Please help me to design a system I have a cable box and a roku as a input source to be connected to TV with cat 6 and also infrared ir all r about 100ft run

This screams ingress..