My phone that I use for the camera had runout of memory space, sorry about the abrupt cut off. I do feel very good about all the lessons learned here. Some where learned and forgotten, but I have a paper record and log and i am summarizing all the results every night so I can share it when the time comes. I am ready to modify all the smokes LIDs Vintage and 3D Printed with these key setups: Input Voltage 8VDC, Set Thermistor Sensor rearward toward the Fan Air inlet to the smoke box. (instant Temp control), target R2 Value 180-220 Ohms with this 20K Thermistor. Pack rock wool in the base of the Smoke box with Angel Hair curled up on top. (Not wound around the heater, but with tail routing down under the rock wool to help wicking process. Center the Heater in the Smoke box cavity, Use PETG to print the smoke housing and anneal the housing at 120C for 20 minutes to get maximum heat resistance. It is working really good with these mods and changed in assembly and setup. More later, Smoke em if you got 'em. D