The SoFlow S03 dont look like this? I want to replace the tire with solid tires. Can you please make a video with the SoFlow S03? And can I change the 8.5 inches tires with a 10 inches solid tire? Or does it has to match the 8.5 wheel size?
I followed the steps and removed the nuts, wire, etc.......but the rear wheel assembly won't "fall out" of the scooter frame. What gives? Do I need to use a freaking sledgehammer on it?
How to change front tire: you must totally remove reflector(it is glued) so either break it off or drill a hole in the middle of the reflector at a distance of 6-7mm from the upper edge of the reflector. there you will find the second screw that secures the plastic guard.
just found it. you must totally remove reflector. It is glued, so either break it off or drill a hole in the middle of the reflector at a distance of 6-7mm from the upper edge of the reflector. there you will find the second screw that secures the plastic guard.
@@Journalisten23 Yes I broke the reflector off, it was glued strong on. Behind the reflector was two screws and I could change the tire. I replaced them with rubber tires so I never have to think about a punctured tire ever again. And ordered some reflectors which you can just put on and placed the new reflectors on the side so it now looks cool.
sorry. Aber wird mit Absicht nicht gezeigt wie der Stecker wieder eingesetzt werden soll. Man hat leider keine Möglichkeit das Kabel festzuhalten und den Stecker einzustecken
@@axelvuille6956 unten vorne die schwarze Kappe mit 4 kreuzschrauben lösen. Dahinter sind alle Kabel dann das Kabel nach hinten durchschieben, Stecker verbinden und dann vorne wieder richtig verstauen
@@theostieber3170 Thank you so much! It's so trivial but still, when you don't know it, you can't necessarly figure it out by yourself (as I did and lost a half day trying anything to solve the problem). It makes no sense that they didn't put it in the video too, just, why? But thanks again und beste Grüsse!
@@theostieber3170 Die Kappe bekommt man vorne aber nicht ab beim So4 Gen 2 aufgrund des Schutzbleches des Vorderrads jedoch kann man da das kabel festhalten... Oder täusche ich mich?
I think that you know why you don`t show how to bring back the rear Wheel into it mounting points. It`s impossible because the space is it is far too narrow to get it in without special tools :( I have two SO4pro. I know what i say.
Kann mir bitte jemand von euch bestätigen dass von werk aus nur drei!!! Ich wiederhole drei!!! Unterlegscheiben beim soflow so4 pro generation I am hinterrad verbaut sind? Von diesen drei scheiben haben 2 scheiben eine art haken und 1 scheibe ist flach. Zumindest war es so bei mir. Ich habe mein hinterrad abgenommen um einen reifenwechsel zu machen und weiss nun nicht mehr wie ich diese unterlegscheiben beim einbau montiere aber ich hatte nur 3 und das video zeigt so weit ich dass sehen kann auch nur 3. Ich bin jetzt total verwirrt. Kann mir irgendjemand das bestätigen. Am besten jemand von soflow oder jemand der bei einem jungfräulichen model so4 pro generation I schon mal das hinterrad abmontiert hat. Vielen dank.