Soda Blasting of a Cylinder Head | Restoration 

What operating psi were you using?

Tolle video🥇 wievil bar hast in kompressor eingestelltbei bei zylinderkopf strahlen ? ❤👄

Erstaunlich was mit Natriumcarbonat möglich ist😳. Gruss DrDuu

A good and practical idea

Just did this to a set of Mercedes Benz cylinder heads from a m113 engine , they look brand new .

Interessantes Video. Gruß Unimedien.

Hi, what kind of soda do you use? I am restoring an old Fordson engine, and it needs a lot of cleaning thanks for your answer.

L8DE mazda/Ford 1.8😂😂👍

Could you use soda on intake valves instead of walnut shells?

Pworrrrr

Bekommt man damit auch Oxidationsstellen weg ?

Soda nicht Sand!

22 Nov 2022, seems like HD gave up or he's dead 3yrs ago. Not allot of information here. PSI??? Type of Gun??? how large a compressor??? job site setup??? job preparation??? What is shown is flash in the pan not the main meal. Really nice job done but I'm a little disappointed in the upload. I dont think he'll read this.

😅😅😅

What's the point? The machine shop cleans it when they service the head, and you should never install a head that hasn't been serviced by a shop (ie checked for straightness, pressure tested, etc ...) Edit: Also this will be "microscopically" pitting the surface which would mean that the newer style MLS head gaskets (which need a precisely machined and polished gasket surface) won't seal properly and will fail prematurely. I would never do this to the valves or mating surfaces.