Standoblue - How To Control Mottling 

Glad it was helpful!

Fantastic stuff . It can be heart wrenching when you only have enough paint for the job and can't waste or make any mistakes 👍

Thanks, we are glad it helped...

Very welcome

Sounds great!

Glad it was helpful!

You're welcome!

Sorry to hear that, good preparation akes all the difference to the final job and the amount of effort involved. Good luck.

Hi, we are afraid we are not familiar with the equipment you mention but for your information our technician used a 1.2 for waterborne basecoats and depending on this type and viscosity of the clearcoat, he used either a 1.2 or 1.3 set up in a compliant spraygun.

Thanks for your question. Applying a control coat over a dried/flashed off surface will cause a cange in colour and effect pigment laydown, creating a coarser efect. It may also lead to die back of the clear coat due to an increase in surface roughness.

Thanks for asking this question. By following this process you will be able to master the application also under more sever climate condition, e.g. higher temperature or low humidity. If spraying the whole bonnet at once and depending on the size of the object and local climate conditions it can be that your first coat might start to flash off before you finish your effect coat.

In this video we focus on the technique to correct mottling in Standoblue.

Yes, no flash off