Stepper Motor Maximum Speed using Arduino and DM542 - How Fast Can It Go?

Подписаться 6 тыс.

Просмотров 1,2 тыс.

50% 1

In this video I show you how to determine the maximum speed for your stepper motor and how to reach that speed using an Arduino and a DM542 stepper motor controller.
Arduino source code for this video is available here:
sciencefuninnovation.gumroad....
The following are affiliate links to the products used in this video. Purchasing through these links may result in a small commission for my RU-vid business which will allow me to continue creating informative content. Thanks for your support!
StepperOnline Stepper Motor
www.omc-stepperonline.com/nem...
amzn.to/4cvHDf4
Stepper Driver
www.omc-stepperonline.com/dig...
amzn.to/3RORiFI

Наука

Опубликовано:

27 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 9

@SupertankCreations 27 дней назад

Amazing video.

@ScienceFunInnovations 27 дней назад

Glad you enjoyed it. Another one on constant acceleration next week.

@SupertankCreations 26 дней назад

ru-vid.comqM1wWu5a4u4?si=YrwqIJkEDMxryWjN@@ScienceFunInnovations

@thomastipton7264 29 дней назад

I am curious about the motors' performance at a high rpm under load. (overheat?) Good job on the setup.

@ScienceFunInnovations 28 дней назад

With high rpm there is lower torque. It didn't seem to get hotter than normal. Next week I will have a video showing constant acceleration which will be better for high loads. Thanks!

@thomastipton7264 28 дней назад

@@ScienceFunInnovations Awsome looking forward to it 👍 👍

@The-KP 27 дней назад

Is there s feedback loop available, some sensing that can tell the ucontroller whether the shaft is lagging behind expected position? Do motors offer positional feedback, or is that a separate attached sensor? Is parasitic sending of magnet position in motors done?

@ScienceFunInnovations 27 дней назад

You can buy stepper motors with feedback. That can let the software know that the motor is missing steps. They just cost a little bit more.

@The-KP 26 дней назад

@@ScienceFunInnovations Very cool! Do you know what that is called, or perhaps some part numbers of such motors?