Rob shows off his newest gift from a fan. Styrene hole punches. Become a Patreon Supporter: / arveymodelproducts Buy Me A Coffee: buymeacoffee.com/thunderbearr Merch: www.teepublic.com/user/arvey-...
They are exact copies of the old Historex punches back in the 70's.If you are not careful they will rust as I can see in the round punch you showed. They do come in handy !
I am laughing my butt off here. I looked at the thumbnail of this video and asked myself when i made this one. Thank goodness you don't have a goatee and sound like me! Or i would really start to question my sanity and think i was crazier than i already am! I gave you a sub just in case LMAO
@@robertvancelit's stainless with an acrylic top. It has nine holes in it. Also comes with a hammer with a brass and a hard plastic head. The two aligning pins sometimes get in the way.
Hi. What if you need say 300 rivet heads ? Your going to spend a long time hammering. Very exspensive tool that needs to be used a lot to justify the cost. I have thought about buying one of these for a long time but there just to much money for me. Regards
There’s a brand called RP Toolz from Hungary that are available in the UK that produce a similar range albeit with more sizes in each set. Not sure if they’re available over the pond but can’t see why not….🤔 They do Hex, rivets and circles ranging in size from 0.5mm through to 4.5mm (apologies but not sure of Imperial sizes) They are expensive but got to be honest they add a whole new dimension to your models. Best Regards Gary
