Тёмный

Subaru Forester Cluster Replacement Cloning EEPROM Odometer Transfer 

Подписаться
Просмотров 12 тыс.
% 132

Thank you for taking the time to watch my videos. Don't forget to Like and Subscribe.
To send your cluster to us click here www.automotivecircuitsolutions.com/products/odometer-correction-service
Note- You will need to send your original cluster and replacement cluster so we can make the transfer. Otherwise we will just program only the mileage and you will have to have a locksmith program the key to the replacement cluster
This will work with all Subaru years and models
2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018,
10, 11, 12, 13, 14, 15, 16, 17, 18
If you have a different make and model you can contact us here www.automotivecircuitsolutions.com/pages/contact-us
Affiliate Links Below
Resistors www.automotivecircuitsolutions.com/collections/other-electrical-components/products/1997-2004-buick-century-regal-display-diy-repair-kit
Helpful Removal Tools for the job
Torx Set amzn.to/33LqVVJ
Pick Set amzn.to/2Huga2q
Plastic pry tools amzn.to/2HPoAxX
Impact drill amzn.to/2DFU4Ed
Impact socket adapter amzn.to/2HLWN1f
Cluster Repair Tools
Hakko Fume extractor amzn.to/2zF5pTh
Hakko Iron tip cleaner amzn.to/2y4x6sC
Weller soldering iron amzn.to/2h8Bv2X
Solder wire dispenser stand amzn.to/2gEADTn
Solder wire 1.0mm amzn.to/2izun3h
Tweezers amzn.to/2phLxTH
Flux MG chemicals amzn.to/2i4XSWT
Desoldering gun amzn.to/2yRSlNw
Kim wipes amzn.to/2y4jVId
Alcohol fluid dispenser amzn.to/2h8JVav
Flush cut snips amzn.to/2BP7LVn

Авто/Мото

Опубликовано:

 

22 дек 2020

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 29   
@alfistasubbie
@alfistasubbie 2 года назад
what did you do at 4:40 taking it away from the screen? The needle was off when you brought it back...
@stephenbrown664
@stephenbrown664 3 месяца назад
Hi I have a second generation 2006 JDM subaru forester. Everything works in my instrument cluster. But the trip meter will no reset physically. I does reset after disconnecting the negative battery terminal.. Do you have any suggestions? Thank you
@osamajassim5204
@osamajassim5204 Год назад
excellent work
@eurowerx4267
@eurowerx4267 7 месяцев назад
Hello What temp did you set the heat gun to?
@alexudolkin2146
@alexudolkin2146 3 года назад
So in this repair only the eeprom chip was swapped and no reprogramming done? VIN, immobilizer and mileage transferred over on just the chip? Thanks
@AutomotiveCircuitSolutions
@AutomotiveCircuitSolutions 3 года назад
That's right. That chip stores mileage and immobilizer data.
@alexudolkin2146
@alexudolkin2146 3 года назад
@@AutomotiveCircuitSolutions do you know if the previous Forester generation (2009-2013) works the same way?
@Thaghossstt187
@Thaghossstt187 2 года назад
is there a way to get the replacement cluster to work and start the car without transferring that chip over to the replacement cluster ?
@edgarflores1677
@edgarflores1677 2 года назад
We’re could I go to get this done ?
@immymak6119
@immymak6119 Год назад
Hi I have 2008 forester just wanted your help which one to swap I can't add photo on RU-vid
@mysticrider76
@mysticrider76 Год назад
Great video. I have a 2016 Subaru STi and just bought a replacement cluster. I also have a sop8 programming clip/usb dongle coming tomorrow. I'm going to try and transfer the original hex from the original eeprom over to the new chip (after backing each one up of course) but my concern is: Are both the mileage & key security stored on the same chip? The chip I suspect is the one to reprogram has MXIC MX25L3235E on the chip. Any chance the VIN is stored on any of these chips?
@AutomotiveCircuitSolutions
@AutomotiveCircuitSolutions Год назад
Yes the key and odometer reading are both stored on that chip. So if you transfer the data on the IC from the original cluster to the replacement cluster then the replacement cluster should show your original mileage and the car should start.
@mysticrider76
@mysticrider76 Год назад
@@AutomotiveCircuitSolutions Thank you for the confirmation. I had to cancel the programming clip I had originally ordered - read some forums where they said the voltage wasn't right and could damage the chip. I'm back to looking around for a good clip/usb dongle that will work for this. Any advice appreciated! & Thanks again for the reply.
@AutomotiveCircuitSolutions
@AutomotiveCircuitSolutions Год назад
@@mysticrider76 We us a $2k programmer for this. Why not just transfer the entire chip like we did in the video?
@mysticrider76
@mysticrider76 Год назад
@@AutomotiveCircuitSolutions I may end up trying that. My soldering skills are "ok" at best and I worry about screwing up the only working chip I have. The last soldering/re-work station I bought on Amazon SUCKED - the hot air was not hot enough to remove components from the PCB board. So I returned the station and looking around for another. Again, BIG THANKS for the quick informative replies! =)
@curtistaylor7627
@curtistaylor7627 3 года назад
I've got a 2005 outback sedan. I swapped out the instrument cluster and I need a chip swap from one to the other. Can I contact you?
@edgarflores1677
@edgarflores1677 2 года назад
The same thing I’m going through
@immymak6119
@immymak6119 Год назад
Hi can you please guide me with these two forester cluster How to clone?
@JEE7600
@JEE7600 Год назад
Is this the same process for an older one? 2008 Subaru Impreza?
@AutomotiveCircuitSolutions
@AutomotiveCircuitSolutions Год назад
Should be similar.
@orton1900
@orton1900 9 месяцев назад
Do general mechanics do this work ?
@AutomotiveCircuitSolutions
@AutomotiveCircuitSolutions 9 месяцев назад
No. This kind of work is typically for specialized electronic repair shops.
@JevaughnGraham123
@JevaughnGraham123 3 года назад
Do you think I could do this?, i'm pretty okay with the soldering!
@AutomotiveCircuitSolutions
@AutomotiveCircuitSolutions 3 года назад
I don't know if pretty okay will cut it on this one. The pins are very close together. This job takes a seasoned soldering technician to do.
@FrancoPN
@FrancoPN 3 года назад
I think you need this EEPROM cable, I have used its very good, don't need to remove IC from pcb board, its for Msop / Tssop, etc, see below, www.3ello.com/home
@naestradacomfabinho4390
@naestradacomfabinho4390 Год назад
Which one is for the key code only pls?
@AutomotiveCircuitSolutions
@AutomotiveCircuitSolutions Год назад
the chip stores both the key code and the odometer. You can send it to us we can transfer just the key if thats what you need.
@christianosorio3418
@christianosorio3418 2 года назад
Estimado como saco las agujas de ese modelo
@immymak6119
@immymak6119 Год назад
Are you on FB or Instagram?
Далее
Outsmarted 😂
00:20
Просмотров 4,5 млн
What Did He Do Wrong?? Wrong Answers Only
0:16
Просмотров 11 млн