Subsonic Wind Tunnel 

نفس العام نفذنا مشروع تخرج wind tunnel فى مصر وواجهتنا الكثير من الصعوبات لذا اعلم جيدا كم المجهود المبذول للوصول لهذا النتيجة ..أحسنتم

I would recommend installing a mesh between the test chamber and the fan. In case your test piece breaks loose, it won't hit the fan.

Excellent work

Very Goooood. I wil try to buld in my University. Very Very good!!

You guys did great 👍🏻 wish all the best

verygood egineer

i suggest you to use multiple smoke channels for better visualization

Hello, this year we will also build a wind tunnel in the final project. How did you make the theoretical calculations for lift force and drag force, except for the value you read from the loadcell? If you have a detailed report (except your slide) with theoretical and applied calculations, could you share it with me?

how many load cells were used?

What kind of fan did u use? Can u share the specifications please?

Great job! Pls which software did you use for visualising the drag and lift?

Which software did you use to connect computer to wind tunnel?

السلام عليكم انا من العراق عندي بحث عن تصميم wind tunnel ياريت نتواصل حتى استفاد من تصميمكم لان محتاج الابعاد ياريت تبعثها لي واني شاكر تعاونكم

What was the drag and lift for the negative attack angle?????

عاشت اديكم.. بس ممكن الضباب شلون صنعتو؟؟

the air speed is 58km/h?

Thank you for the video.Can you please provide the circuit diagram ?

Hi, I watched your video and liked it. with a quick question. I am building a wind tunnel for an engineering school project and need to measure lift/drag. I have two load cells and two hx711 amplifiers. I downloaded the source code and was able to get one load cell running, but I don't understand the code well enough to read the voltage from the second load cell. Any help or guidance would be greatly appreciated or can you throw the codes you used

make more vids plz

Hi- could you please give some insight into the angles of taper(relative to the top of the viewing chamber) that you used from the viewing section to the fan end and open end respectively.

sir, please send me the total dimension of the wind tunnel manufacturing

thank u for the video .i want the dimensions of this wind tunnel

Thanks for sharing the wind tunnel design, could you please tell how you measurement drag coefficient using arduino and load cells and its connections, it would be really helpful....

Hi sir! sorry wanna ask, what standard is used in this wind tunnel ? thank you

How did u make the fog

Hi! Can I see the Arduino codes? Thank you

Thanks a lot for sharing the video.Can you plzz provide the working code of Arduino and electronic circuit details?

what was your smoke source?

Hello! Do you have detailed documentation, so I can build an identical one? I am an Electrical Engineer, I work with solar energy. If you need anything in this area, I can help. Thanks!

Which software are you using to get immediate values for drag and lift on laptop

Calling bs. As I see it.