I explain how to set the Super Bee for use with a 3 channel radio. Plug the Super Bee into your Aux channel, and both dip switches should be up. www.KillerRC.com for more info or to purchase a Super Bee.
Does Super bee kill switch work with Spektrum AVC because my Spektrum AVC interferes with it. When the AVC is on, the kill switch automatically turns the engine off and it doesn't take any input from the transmitter thereafter. So I have to turn off the AVC and then the switch gets turned on or off from the transmitter.
Osmar Castillero I did every single test And I notice if you or if the coil cable get disconnected from the supper bee kill switch the engine still running. I tape my around to make sure will not comes off
Yes. Make sure the ignition wires wires are securely connected to the ignition coil. You can pinch the spades with pliers to make them fit more tightly.
Treat the receiver like its a 2 channel receiver. There will be power on channel 3 and 4 but no signal. So you'll need to put a splitter cable on the steering channel for the Super Bee. Flip down the #1 dip switch on the Super Bee to turn off Aux control.
Joe Milnes With a 2 channel transmitter, If you plug the Super Bee into channel 3 or 4 the Super Bee would think there is a constant radio glitch and you'd never be able to start the engine.
For a 3 or 4 channel radio you don't need to change any settings on the Super Bee. Just set the radio like this. www.killerrc.com/forum/viewtopic.php?f=13&t=1077
Roderick Taylor Does this only happen when the engine is running? It could be radio interference from a bad spark plug resistor. Install a new NGK CMR7H spark plug and try it.
For installation on a HPI Baja see this www.killerrc.com/forum/viewtopic.php?f=25&t=586 For installation on a Losi 5IVE see this www.killerrc.com/forum/viewtopic.php?f=25&t=565
Depends on what radio you have. You probably just need to change how the failsafe is set on the receiver. Hold down the Aux button (Super Bee LED red) while you rebind the transmitter and receiver. Try that out
crazy4baja Both dip up on the Super Bee. Plugged into the Aux. Hold the Aux button in the off position (Super Bee LED Red) while you rebind the transmitter and receiver.