Surface Cleaner bearing replacement 

Fucking A+ bro I have a edou 20inch, this just made me me confident af, love it, RU-vid is the dad I never had

Great video. 6302 bearing. For mine, I used an S6302-2RS, stainless with two rubber seals. $6 each (2 required) on Amazon.

Upon pushing the bearings back into the housing, he should have never hammer it back in. You just end up scratching the inside. Just apply little grease inside the bearing housing and outside the bearings itself and it should slide in like butter. Also apply small grease between the first bearing and the second as you pushed them done on the piston if you like to call it piston. It will work flawlessly. Thank me later

Great video, thanks! I appreciate that you added the comments.

This was very helpful thank you

Great video! Where did you get those pliers from?

I like that background music.. who? Would this same concept apply to simpson surface cleaners?

Deep groove bearings?

Are there any o-rings to replace? How does it seal water in? Do you have to take 4 cap screws and locknuts off? I am about to tear a 20" one apart.

thank you....did yours lose power when it went bad

What size are those bearings

On my lanz surface cleaner the rotating rod falls out.oes the clip stop that

Is this a Mi T M surface cleaner?? My beavis locking up on me on a job right now and I don't know how to fix it

What is the bearing number?

Good video, that swivel looks like the same one on the GP Hammerhead, the BE, Whirl A Way and a couple others, in your opinion is it the same swivel? Thank you.

Jeremy, the ring you pulled out at 2:10 do you know what size it is. I brought mine and no store around here in my area has one.

What size bearing are they do you have the number.

U didn't Evan grease It u wrongun