Спасибо, дружище, я рад, что видео помогают. В следующем году, когда погода улучшится, будет много видео о радиочастотных двигателях, и все будет в порядке.
This is a little bit off topic but I'm having issues with my mates rf900. It doesn't run evenly at 3500rpm which is terrible in traffic. It sounds like a fluttering or lack of fuel/to much air. Ihave cleaned the carbs, replaced the plugs and inlet rubbers (one was cracked and constantly sooted the plug) but still the problem is there. The bike is much better now, faster, quicker and rev happy but this 3500rpm issue is bothersome at the best. Do you have any ideas? Thanks for the videos, I'm replacing the rear shock this weekend.
Most often things like that are caused by carbs issue.You cleaned all fuel jets and air jets? Clean carbs is good but they need to be assembled correctly(every little washer etc) and set up well(needle heights, mixture screws, float heights etc) Another possibility is that they might need a rebuild. If you internal gaskets and orings are shot fuelling will be off. Needles and emulsion ubes wear out too and if those go it's almost impossible to gets things right. You could get a litetek rebuild kit for about £45 and try that. It has all rubber components needed to refresh carbs. It doesn't have the tubes and needles but might be enough to get it sorted.