Testing 15 Lego Propellers - Lego Technic  

It was educational and fun! Thank you!👍👍👍

It was fun, but it felt like it lacked the basic understanding of aerodynamics. I suggest you try the same tests next using smoke, then you'll understand a lot of misconceptions about how these stuff works. Like why the ball did not move close to the propeller but was sped up at a distance, or why non wing like "propellers" did not work.

@DrEngine It was very interesting! Thank you! 4:40 As a building tip, though, when building custom-made propellers using LEGO Technic panels like this, try not to build perpendicular to the axis of rotation like you did in this video, as the centrifugal force acts outwards on the propeller blades. What I mean by that is, try using pairs of either the 3L Technic universal joints (for controllable and variable-pitch propellers) or the 3L Technic angled axle connectors to mount the blades parallel to the axle or axis of rotation, and reinforce the blade connections on both the bottom and top halves of the propeller hub. 3L Perpendicular Pin and Axle connectors can be used to mount the blades onto the hub. I've found that this design is much more resistant to centrifugal force and can hence spin at much higher speeds (even ludicrous BuWizz or buggy motor speeds) without breaking apart. I will provide links to the parts I am talking about below. www.bricklink.com/v2/catalog/catalogitem.page?P=42003#T=S&O={%22iconly%22:0} www.bricklink.com/v2/catalog/catalogitem.page?P=32016#T=S&O={%22iconly%22:0} www.bricklink.com/v2/catalog/catalogitem.page?P=62520c01#T=S&O={%22iconly%22:0} Hopefully this helps! :)

@@Sonnell The ball did not move closer to the propeller because thrust from the propeller was exerting a forward force on the ball until the force of gravity interrupted the ball's motion (on steeper inclines). And non-wing propellers can work as long as each blade is set an angle, they are just less efficient than propellers with more aerodynamic blade types. Moreover, the propeller failure at timestamp 4:40 resulted from a structural integrity issue directly related to the propeller's design, not its aerodynamic performance. Centrifugal force acted outwards on the blades and overcame the frictional forces that held those blades to the propeller hub.

Very funny Videos! 😊

Also different amounts of power in each run.

go-go gagit pixel reducer 0:01

OH NO THE PIXELS! WHERE THEY'RE GOING?! [screams in 8p]

Lmfao

Glad you like them!

hi

Amazing tips, thank you!

also have the same amount of power behind each of the fans instead of changing it. that really messes it up when available power is changing (some of the earlier fans would have benefitted from more power but you didn't give them it then you gave later ones more power) unless you did keep the same number moters

Thanks! 👍

Great to hear!

Glad you enjoyed it!

Hey the flaps on the fan you maid is reversed that's why it didn't work​@@DrEngine

Glad you like them!

Thank you! Cheers!

Thanks for the tips!

So, What makes more blades?

Nice suggestion!

Everybody do the flop

Thanks for the info!

Noted!

Thank you so much!

or shows the influence of the propeller on the engine ;)

He needs to use a brushless motor or put more motors

Thanks for the tip!

7:56 bro make an whole tornado

Nice suggestion! Thank you ☺️

@@DrEngine your welcome

scammer.