#fuel #diy #automobile #repair
VIDEO INDEX:
00:01 Intro
00:46 Explanation
01:55 Fuel Pump Location
02:42 Pump Panel Removal
03:01 Disassembly
07:00 Removal
08:15 Compare old vs.new
08:38 Install Prep
09:28 Installation
12:47 Leak Test
13:15 First Start, then Finishing Up
14:00 No Fuel Filter?
14:36 Video Wrap Up
================================================
Welcome to another episode of The Eight Nine Garage. Replacing the fuel pump in a 2011 Ford Escape is a fairly simple procedure, provided you follow the necessary steps and precautions to ensure safety and proper installation. Here's a general guide on how to replace the fuel pump:
Note: Before starting any work on the fuel system, ensure that the vehicle is parked in a well-ventilated area and that there are no open flames or sources of ignition nearby. It is also advisable to keep a fire extinguisher nearby.
Tools and Materials Needed:
Replacement fuel pump assembly
Safety glasses
Screwdrivers
Pick Set
Hammer
Container for fuel drainage
Rag or towel
Preparation:
- Park the vehicle on a level surface and engage the parking brake.
- Disconnect the negative terminal of the battery to prevent accidental ignition.
- Relieve the fuel system pressure by removing the fuel pump relay or fuse and then cranking the engine until it stalls.
Accessing the Fuel Pump:
- Locate the fuel tank access panel under the rear seats or in the cargo area. It may be necessary to remove some trim pieces or carpeting to access the panel.
Removing the Fuel Pump:
- Disconnect the electrical connector(s) from the fuel pump assembly.
- Remove fuel pump retaining ring
- Disconnect the fuel lines from the fuel pump. Be prepared to catch any fuel that may spill.
- Carefully remove the fuel pump assembly from the fuel tank, taking care not to damage the float or other components.
Replacing the Fuel Pump:
- Compare the new fuel pump assembly with the old one to ensure they are identical.
- Install the new fuel pump assembly into the fuel tank, making sure it is properly aligned and seated.
- Reconnect the fuel lines and electrical connectors to the new fuel pump assembly.
- Reinstall retaining ring.
Testing and Reassembly:
- Reinstall the fuel tank access panel.
- Reconnect the negative terminal of the battery.
- Turn the ignition to the "on" position (do not start the engine) and check for any fuel leaks.
- Once confirmed there are no leaks, start the engine and check for proper operation of the fuel pump.
- If everything is working correctly, reinstall any trim pieces or carpeting that were removed.
Cleanup:
- Dispose of any spilled fuel properly.
- Clean up any tools or equipment used during the procedure.
- Double-check for any leftover parts or tools underneath the vehicle.
Testing:
- Take the vehicle for a test drive to ensure proper operation of the fuel pump and verify that there are no unusual noises or issues.
Note: This procedure is a general guideline and may vary slightly depending on the specific model of the 2011 Ford Escape and any variations in its design. Always consult the vehicle's service manual for detailed instructions specific to your vehicle. If you're not comfortable performing this task yourself, it's advisable to seek professional assistance from a certified mechanic.
================================================
Amazon Links:
Fuel Pump:
amzn.to/3TtJetV
Pick Set:
amzn.to/3Vzz1yH
Dielectric Grease:
amzn.to/4cHvTan
15 сен 2024