"The LEVEL5 MiniShot is INSANE" 🔥  

You still have to fix the 3 ways anyway so might as well go corner to corner then you dont have to fix the pull off in the middle

@@BaadMotorFinger just the way I was taught. Neither way is wrong. The single center line is gone when you pole sand the angles before the final coat goes on angles. Three ways need to be nice so no sense pulling off in the corners. Start carefully in the corners with the flusher head and do your left, right, and down swipes.

​@@69yenko65corner to corner no lift offs to sand and it leaves mud to do the three ways.

Dewalts' is made by level 5 It's basically a smaller version of the Dewalt mudshot.

It is messy, but ai never use the box. Maybe if you have used the box before you should be fine with the minishot since it is supposed to be more controllable

Have you tried a tube, not as fast but easier than the corner box

For sure... lol

I've used the Dewalt MudShot and the TapeTech Mudrunner. The Mudrunner is poorly made junk. The Dewalt was pretty good but both leave more mud than needed. The finish isn't that good. I use the Columbia Throttle Box now and it's my preferred method.

Hay trabajo

I hate they are made in China, I will buy one of these but that's it. I support my fellow north Americans

Way easier.

Variables. Blades on head need to be set right. Consistency of mud. If the head is to full when the angle is started it can (not always) leave edges. Valve setting. Was the angle taped correctly? Many people think they can wipe angles correctly by hand but leave rounded inside corners. Many people don't roll with the tool tight enough and that in turn will have this tool leave to much mud( it shows up in the base trim. Once all that is learned and applied there is no need for further hand work other then the start and stop points.

No, if you thin your mud enough you’ll be close but you’ll still have to do feathering coats with a knife away from the corner, same as with a corner trowel. This just saves you having to coat one side of the corner and having to wait to do the other side.

10 mins tops just need a hose it comes with the adapter.

I Sean the angel be glazed with that I didn't agree but they do it

@@markbates2059 what

@@mehmedasotic584 when you roll an glaze angels in stead of the glazer they used that mud shot that's putting wet over wet

4-5 half tile sponges.

@@user-iq9uu9mh7k thanks

Yes

I use a 2.5" to tape and a 3.5" to skim....turns out beautiful

Not at all, it's an incredible tool. If you do drywall I highly recommend it

I wouldn’t recommend that shit look at the corners they smeared

The original mudshot is kinda hard to but the ease of running the tool outweighs it.