The Trigger Job 

One question I am fitting a new Wilson sear and hammer to my Springfield 1911 and I rack the slide back but the sear misses the full cock natch by thousand I just touch the hammer and it locks in seems like the sear is just a little bit to long i mic it from center of pin to tip of sear I get about .4025”

I wish the video was clearer!

I am not sure. I just know it as a hard Arkansas stone. I also use medium and fine India stones for more material removal.

Good info and teaching skills . Thanks

It was made by Marvel, however, they no longer make this model

What grit is your Arkansas stone? What are your favorite stones for smith work

Is the gig you're using for the hammer/sear work a commercial one or something you've done it yourself? Would love to get my hands in one of those.

Very good job

Who's fixture is that?

MOA, where are you located? If I send you a hammer, sear, disconnector, and sear spring, could you do a "trigger job" like this for me and send them back?

I need that fixture!!!

what is the name of that fixture PLEASE ?

Once you do this to the trigger what is the benefit?