No video :(

Thermostat Controller W1209 for Incubators

Подписаться 48 тыс.

Просмотров 12 тыс.

50% 1

W1209 module is widely used in Incubators to maintain a temperature of 38.5 deg celcius to Hatch Eggs.
This video walks you through the settings to be done .
For incubator P0 setting is done to H Hot condition, where the relay is ON till temperature reaches the setting 38.5 deg C.
C cold condition is also explained where a DC Fan is switched on at a Set temperature.
www.alselectro.com/digital-the...
video in Tamil :
• Thermostat W1209 Setti...

Опубликовано:

9 окт 2020

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 14

@kashif8704 3 года назад

I like the way you explain things. Doing good job.,,,

@nava-kit 2 года назад

nicely explained

@georgebreckenridge3351 8 месяцев назад

Good overview thank you !

@hananben415 Год назад

Thank you very much sir!

@vai.jagadeesan 3 года назад

Super.... annaa👍✌

@stanley1591 2 года назад

Hey! I enjoyed watching your video, and happen to be working on the same. How would you go about connecting both the bulb and the DC12v fan in the same circuit? In essence they would operate in sync when on, the fan distributing heat from the bulb throughout the incubator space. Thoughts?

@kadhiravank4210 Год назад

It will used for Cold storage devices? Reqd temp like as 0°c to -10°c. Is possible to set this .

@sayantanmaiti2513 3 года назад

whats the microcontroller used here?

@ashishpaulgeorge1981 10 месяцев назад

Hi, I tried to make an incubator with the same settings. But the bulb is not working. When i give the wires direct the bulb is burning, i tried the same wiring and did all combinations but the bulb not burning when connected to w1209