TILT and TRIM Installed on Small OUTBOARD Jon Boat BUILD

Подписаться 14 тыс.

Просмотров 34 тыс.

50% 1

I installed a Bobs Machine Tilt and Trim onto my small 15hp Johnson outboard. Everything I did on this installation is in this video. Looking forward to a top speed run and seeing just how this little 14 foot Jon boat maneuver at high and low speeds! As always Thanks For Watching!
Previous Boat Videos:
• Replacing TILLER with ...
• Throttle and GEAR Shif...
• Jon Boat SUSPENSION Se...
• Jon Boat Aluminum FRON...
• FIRST RIP on my TINY B...
• Electric CHOKE and STA...
• Flooring.. Trolling Mo...
@kentuckyyankee
#tiltandtrim #outboard #jonboat

Авто/Мото

Опубликовано:

26 мар 2022

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 27

@robertwright1083 Месяц назад

You did a great job and also in making this video. thank you, I'm saved for solving my problem.

@larrybalowski946 7 месяцев назад

Great job

@eamonnocarroll5866 2 месяца назад

Thanks

@darthjar9117 2 месяца назад

Stainless steel lock nuts were too expensive?

@samueldoyle1656 Месяц назад

Stainless makes aluminum corroed faster

@PaulyV56 2 года назад

nice work!

@kentuckyyankee 2 года назад

Thanks! I'm gonna lower the engine 1 inch I think it will preform better stay tuned.

@philwalden6166 Год назад

A nice video, but I did not see the tilt trim assembly be installed which was the very most important.

@jacobmorris9830 Год назад

Is your motor a long shaft? I have a short shaft transom and motor and am wondering if this acts as a Jack plate or can I continue to run the short shaft with this unit

@alexopweg Месяц назад

Nice job . How much does it cost please???

@chadbosko8935 8 месяцев назад

Looks like i have the same unit to install and directions mention nothing about the height you put yours flush at the front isnt that going to raise your motor much to high and it wont run right. Watching the end of your video, the motor looks a lot higher than the transom how did the motor work like that?

@KimNguyen-or3tt Год назад

good job buddy ! i would like to have that for my 20 hp honda some time,

@kentuckyyankee Год назад

I like the trim but as far as performance not much advantage as far as I can tell.

@garlandhood9729 2 дня назад

Do you still have this boat I have same set up but my boat is a 12 foot boat with those beaver tail aluminum pods welded on back it does very good it ran bout 35 mph with just me after pods welded on it slowed down bout 5 mph. Yell back at me

@kentuckyyankee 2 дня назад

I sold this one awhile back. It was fun while I had it.

@justchipsfishing8951 Год назад

Hi mate. Do you have a link to purchase one of these? My 30hp merc needs one asap hahaha

@kentuckyyankee Год назад

Google Bob's Machine tilt and trim, there will be many options.

@justchipsfishing8951 Год назад

@@kentuckyyankee thanks mate

@JupiterGeorgeFishing Год назад

Not trying to be an ass but if you ever hit anything the engine won't pop up now because of the way you locked it in with that piece. Just be careful about that...