I have this same issue Firmware has been reinstalled, CLI reimported, both bind via CLI & via quad do not work. The below guidance from EMAX doesn't instill much confidence either: 5. Binding Drone Standard Method - Plug charged lipo batteries to the drone. The next step is easier if the battery is hanging free, out of the battery strap. Using a non-metallic object, hold the Bind button on the bottom of the main board for 2 seconds. Bind your radio transmitter in D8 mode. Keep the transmitter at least 5 feet away from the drone to allow for proper binding. Unplug the lipo battery from the drone. Turn off the transmitter. ----------------------------------- Please note that the TinyHawk II Freestyle is only specified for use on D8. However, you may choose to use the following if forced to bind in D16 (i.e. newer ACCESS-based FrSky radios, but with ACCST16 firmware updated). Note that you may encounter receiver/failsafe issues, and this method is not supported or guaranteed to work. Warranty does not apply when using this method. CLI Method - First, change the receiver protocol in the Configurations tab of Betaflight to SPI-based receiver, Frsky_X protocol (which is for D16; the default is Frsky_D for D8). Next, try using CLI commands to bind. Enter into the CLI, "bind_rx" (for 4.1.x firmware) to get into binding mode. Activate the bind function in the transmitter in D16 protocol. The drone's LED's may not change back to blinking, but continue. Then enter into the CLI, "set frsky_x_rx_num". If the rx/receiver number changed to the number that matches the receiver number shown on your transmitter, then the bind was successful. Finally, enter into the CLI, "save".
No it was working and just stopped i contacted the company they said maybe its the flight controller so they sent me one but in the meant time my radiomaster tx16s came in the mail I binded it to that controller noproblem and it started working again
Yea the one that comes with it is to cheap but on the plus side if u get a good controller like the radiomaster tx16s u can use it for all the quads u buy plus u can use it on simulators to practice
Once I tried binding it to the radiomaster it worked no problem I got ahold of the company before my radiomaster came in the mail and they sent me a new fc but it started working with the other controller so I guess I have a extra fc
The e6 controller only works via the D8 protocol (as far as my research suggests) The e8 bigger squarer controller works in D8 & D16 (frsky D & frsky X respectively)
