Top Common Engine Problems 2007-2013 Chevy Silverado 1500 Truck 

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*

Had a 2009 Sierra. I had to replace the oil pressure sensor twice and had crazy oil consumption. I replaced the valve cover with the bigger pcv valve in it and switched to full synthetic oil and it stopped burning so much oil. But I had a nearly trouble free 200k before I traded it in. Great truck!

I have a 5.3 with 292,000. It's never had any engine work and runs great. And it's in a van that is always full.

We have two trucks with the 5.3 and the 6.0 and love them both, both high mileage and doing great, thanks.

I just added an oil catch can to my 2013 and it’s amazing how smooth my idle is now and it’s crazy how much oil it catches in so little time

Broken exhaust manifold bolts. Causing an exhaust leak "ticking" which a lot of people think is a lifter. Gm went with regular old bolts on the exhaust manifold and after about 10yrs or so the bolt heads break off from stress and heat cycling; then the manifold moves away from the head and leaks. Extracting these broken bolts can be extremely difficult especially if it's the dreaded driver's side rear there is very little access. The bolts that break are usually driver's rear, driver's front and passenger rear. They sell aftermarket clamps that bolt to preexisting holes in the cylinder head then a bolt puts pressure on the manifold to seal up a leak. It's a bandaid but can work. So gm knows about the issue and designed around it. Most manufacturers use studs to avoid these problems.

Great content you just solved my problem today!! Thank you amigo

I'm surprised the lifter failures from the AFM system weren't mentioned. Caused me issues when i had my truck.

Have a ‘13 Silverado. Bulletproof with just basic maintenance!

How about the 4.3 - v-6 engine review of problems on 2007 - 2013 models .

What about the lifters in cylinders 1,7,4,6? They wipe cam lobes, bend pushrods and destroy rocker arms.

Great video! I fix all those problem except knock sensor.

thanks for thr video..im in the market for 07-13 1500.

Ty

The 5.3 had porosity issues when the aluminum blocks were cast, didn't fix it until 2015. See the TSB, leaks coolant into the bores. solution is a new engine.

is the 4.8L a good motor? Found a absolutely mint 2007 short bed reg cab 4x4, but has the 4.8L engine. Thanks.

The 305 V8 is one of the last engines GM made right. They rely on an old technology (waste spark ignition as opposed to coil-on-plug ignition) but that technology is pretty much bulletproof per its simplicity. Only thing is, when you service the distributor cap and rotor, make sure to align the rotor to the correct time, otherwise your ignition will be ever so slightly out of time, causing the engine to run rough.

i am excited for tmrrrrr

Hey 1A-Auto , U guys also suppose to mention next: That GM engine: especially v8 are very sensitive with: 1. oil change postponing. 2. Oil consumption burning (afm or dod systems, all , all , all issues are these AFM, DOD. innovation in these vehicles, Because previous generations till 2006 was regular hydraulic lighters but no v4 or v8 gas savings mode, . That AFM DOD, killing previous good GM engines reputation, A lot of people have to doing expensive AFM,DOD DELETE KIT AND BIG JOB DONE,.[ or buying RANGE DEVICE $220] AND KEEP IT PLUGGED IN ODB PORT ALL THE TIME.👍🙏 . 3. Head gasket blows and leaking after 150,k.miles. on these vehicles. So please make a new episode, and mention these only three major Issues on these v8 engines : 4.8, 5.3, 6.0, and 6.2L Called AFM (active fuel management) From 2007 to 2010 or 2020 BUT from 2020 and 2021 they make again something new , some customers says that that experiencing even worse things Called DFM(dynamic fuel management). So they asking GMcomp. To make a recall, And now gm offering a some Silverados with out DFM and fully working v8 fully time engines on these trucks.🤝👍👍👍

Please make another video. You did not address the AFM lifter issue that can require cam replacement. The seal on the oil pickup tube is also a common issue.

My flywheel was my biggest issue!

Good info. Wouldn’t you say the lifter tick is fairly common also. I don’t know one that hasn’t had it at some point. But great video.

I bought a 2012 April of last year. When I buy a used vehicle, I always change all fluids front to back even the gear oil in front and back differentials. The truck takes 6 quarts of full synthetic 5w30 oil. Here's what happened to me one day.... In January my family and I were coming home from taking my son to the doctor when the check engine light came on. I got the truck home (Thank God) hooked it up to my OBDII scanner and it wash the oil pressure sensor. I was going to replace it but a guy on here told me to check my oil first. When I checked it, the dipstick didn't have a drop of oil on it. (I FLIPPED OUT) I just paid $18K on this truck! So, I went ahead and ordered both valve covers because I wanted both of them to be clean and to also match one another. I've installed both of them, but I've not checked to see if it worked because after installing them the passenger side pcv outlet on the new one has a flared end on it and the original didn't have that. So, I went to Advanced Auto to buy a rubber hose to use on it after I cut the pressure clip off of the pcv hose. I also decided to get me and new gas cap while I was at it. Anyways, I hope and pray that the new valve covers help the "Oil Consumption Problem." I'm sort of worried about it though because that's a lot of oil being consumed in just 4,000 - 4,500 miles. Yes, I've also checked for leaks and there were none. I've seen vehicles that are burning oil, but this truck doesn't do like that. The only time I've seen blue smoke out of the exhaust pipe is when climbing a hill, but it's just a small amount and then it's gone. If you were not paying attention to it, you wouldn't notice it. I've also checked my antifreeze for oil to and if good. Another thing, after I change the oil the dipstick doesn't read right which has me stumped. It should be on the full area, but it shows as if I put 12 quarts instead of 6. I'm thinking it got the wrong dipstick in it, but if anyone knows something different let me know.

Thanks 🙏🏼 Good information.

Driver side motor mount. Buy the solid mount that is for the Hummer H3. Also get a tuner and turn off the AFM.

2007-2013 GMT900 Platforms are notorious rust buckets.

2010 Silverado cranks over good only fires every 4-6 turns overs before start, like no fuel but after 3rd key turn it smells like it is flooded. I do the most evil thing at that point and hold key to on and peddle to the floor if it dosent start after the 3rd. only happens in morning and after work you turn it off and it fires up right away, with in a half hr or so after first start. what do you think?

I know he mentioned the 5.3 and 6.0. Anyone know if this is the same for the 4.8? Thanks.

I had a stuck lifter as well due to the afm. i fixed by using crazed performance method on youtube, not terribly hard to do

Always have issues with low oil pressure - already replace the sensor and screen twice and it keeps happening . Now I also have an issue where it cranks and it does not start . When it starts black smoke comes thru the muffler pipe

5.3 flex engine knock sensors

What about the stuck lifters from the fuel saver function. Where it goes from 4 to 8 cylinders - to save fuel - then the issue with the lifters that stick!

I used a range tech to turn the afm off and have had no problems. I used to get fouled 1 and 7 spark plugs.

How do you change Celsius to ferinheit 2010chevy Silverado

I'm looking at buying a 2013 Silverado 1500 with 175,000 miles for my son. I keep seeing info about the AFM and having lifter problems and such. Would that be for a 2013 as well? What years are the best? He loves the Silverados

I’m looking at a 2010 LT with 198k, with a new transmission. I know it’s high miles but it runs and rides smooth like new. Any feedback?

What is the code po 130 or po 150 on Silverado track 2013 1500

Haven't had any problems yet,but only has 235000 miles. Not broken in yet

Same problems for the 2010 model?

I have an 07 Sierra with the 4.8l. Love the truck. Do these apply to that engine too?

Do you have a video on the 2014 up, 5.3/6.2 Ecotec issues?

98 chevy silverado 4x4

I have the 2007 5.3. I'm approaching 120k with it. What would everyone suggest I do in terms of maintance to prepare for the milestone? Truck was well taken care of by previous owner (elderly man) and I have changed the oil regularly. Bought it 2 years ago at 86k miles, have 118k now. Recently replaced the throttle body 150miles ago, but am having trouble relearning the idle manually. I want this truck to last so any advice is well appreciated!

I have searched and searched. My problem is simple but not sure on the repair. I have a 2011 Silverado 1500. My pickup runs great but coming home today the rpm gauge jumped up to 5k but the pickup speed and sound did not change! when I reached home and shut the truck off the rpm gauge stayed at about 2500. Trucks running great, no problems, no warning or codes showing. HELP

6.2🙂

Any one hear a random thud after start up! On a 2013 yet! Guessing it's just my bad luck! :)

Bullet proof?

Lifters

Build dates of February 2011 to 2013 are the fully updated Gen 4 LS V8s that are bulletproof reliable. Just plug in a Range Technology dongle v4 disabler and change your oil ON TIME!!!!

What about after 2013

The last thing you say is nothing goes wrong with the timing chain but the timing chain tensioner is a common problem and what is wrong with my 07 5.3

If you do regular oil changes, you probably won’t have any of these issues prior to 200k

The world wide known problem of lifters & AFM issues is for another entire video?

Gm 3.6L v6 engine please.

No timing belt?

People give gm crap for their pcv system and stupid afm and dod system but like you said one thing they built really smart is their timing system, compare 1 gm timing chain to one in a toyota or better yet an audi engine, youll find how complex and complicated they are and that to me adds up to mor possibly fallure points

Do you think this issues apply to the 4.8 engine size 🤔?

can I replace my 5.4L In my f150 with one of these!

I'VE BEEN SHADOW BANNED BY 1A AUTO!

AFM issues? No?

Got a 92 Silverado. Gas has 2 catch up with gas pedal

🤣🤣 these trucks got so many problems they have to make this one engine specific!

Tick,tick,tick?

I never wondered but why did my 2013 Silverado 1500 lt come with a vtec? I’m not the brains when it comes to engines 🤣

These motors are FAR from “bullet proof”

I never had issues with my truck... at 257k. 4.3 litre

🙂☕👍

My 13 silverado leaks oil like a SIV it's a POS

Stay away from GMC. I have 2013 GMC Sierra. Bought brand new. It is a POS! Has the GMC known lifter/cam shaft defect at 123K miles! Why isn"t there a class action suit against GMC for continuing to push out defective engines???

Great info. Great to hear about our trucks engine. We have a lose of oil bad between changes, looks like the valve gasket is a start to fix it!

Don’t forget the engine keeps flooding, wet spark plugs etc