Toyota Highlander/ kluger Tail Light Bulbs and tail light assembly Replacement.

Просмотров 16 тыс.

% 75

This video show how to do the steps to replace a rear brake light in a 2009 Toyota Highlander/kluger.
If you are looking for help with your Automotive Repairs, Automobile Installations, Mechanical Repair or Adjustment, please head over to carfix for information on it
Please drop your comments and subscribe if you like my videos. Thanks for all the support.
3/8 deep 10mm socket:amzn.to/3yhu6WE
trim removal tool:amzn.to/3CA5RFM
kluger tail light:amzn.to/3SKH6ws
1/4 socket set:amzn.to/3SQiQIY
long screwdriver:amzn.to/3e5wWYa
*Disclaimer
We are not responsible for property damage or injury incurred as a result of any of the information contained in this video. Information given in this video does not guarantee the desired outcome. Any injury, damage or loss that may result from improper use of the tools, equipment, or the information contained in this video is the sole responsibility of the user and not carfix

Авто/Мото

Опубликовано:

29 мар 2022

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 12

@davidjames2723 Год назад

Anyway this is the best tutorial on changing the rear lens so far, but think ill try to get my hand thru the access hole just to change the brake light bulb on mine, thank you

@pngmick 2 года назад

True. Looks like you can get to the globes without taking out the lens. I have to replace it tomorrow and this gives me some pointers. But what a silly oversight by Toyota, having to remove so many trims to do this job.

@nickkokkinakis2136 2 года назад

That was not necessary to remove all that covering. From the side cap door you could reach with your hand and turn the bulbs. My mechanic showed me as he replaced my brake lights in 5 minutes.

@fah8600 6 месяцев назад

You don't have to dismantle the entire light assembly to replace the bulbs. You can access them through the panel located just behind the assembly.

@GangsterishlyMelodic Год назад

You'll have to do this after dropping the new bulb in the lamp assembly by accident

@9graff9 23 дня назад

Are these taillights LED?

@carfix1993 23 дня назад

@nhatnoshida6928 2 года назад

what type of deep socket you're using ? may I have the link to buy it. Thankyou

@carfix1993 2 года назад

10mm deep socket

@ppalom2245 Год назад

No, no, no! You don’t need to remove all those parts. Go watch another video. You only pop off that one small square grid - reach in pull out the bulb wire - replace the bulb - and slide it back un. It is a liitle tight fit, but nothing compared to what this dude has you do. Geez!!