Toyota Rav4 Tacoma Digital Clock Repair Display Fix

Просмотров 5 тыс.

% 89

Thank you for taking the time to watch my videos. Don't forget to Like and Subscribe.
If you would like to send us your clock you can purchase the service on our website. www.automotivecircuitsolutions.com/collections/clock-repair-1/products/toyota-lexus-clock-repair-service
Tools that i use in the video:
Hakko Fume extractor amzn.to/2zF5pTh
Hakko Iron tip cleaner amzn.to/2y4x6sC
Weller soldering iron amzn.to/2h8Bv2X
Solder wire dispenser stand amzn.to/2gEADTn
Solder wire 1.0mm amzn.to/2izun3h
Tweezers amzn.to/2phLxTH
Flux MG chemicals amzn.to/2i4XSWT
Desoldering gun amzn.to/2yRSlNw
Kim wipes amzn.to/2y4jVId
Alcohol fluid dispenser amzn.to/2h8JVav
Flush cut snips amzn.to/2BP7LVn

Авто/Мото

Опубликовано:

6 фев 2018

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 20

@sharkinthedark1 4 года назад

Awesome, worked like a charm! Thanks for posting.

@davidnovotny2265 3 года назад

Great video. You solved the problem!!!!

@shanecannon4698 4 года назад

Thanks so much. Very helpful video.

@danieljackson1272 2 года назад

What is that you're doing immediately after you finish soldering? Also, the clock in my 98 Toyota RAV4 a couple weeks ago began illuminating somewhat weaker whenever I'm sitting in the car with the engine off listening to the radio. The illumination will be weaker on either side of the numbers but slightly stronger in the middle. However, when I start the car, the illumination is at full strength. Any idea what might be causing that?

@ramper50 4 года назад

THANK YOU!!

@tomtaddei4536 4 года назад

This fix work perfectly on my 1st Gen Toyota Tacoma... The circuit board you fixed was identical to mine... THX

@JohnDoe-gz8dw 4 года назад

I gotta ask what color your clock displays???

@tomtaddei4536 4 года назад

@@JohnDoe-gz8dw green

@stormer6364 4 года назад

How difficult was it to remove?

@whatisdreup2 Год назад

Can u solve the great mystery of the suzuki samurai 86-88 digital clocks that always stop working ?

@dtec30 3 года назад

how do you remove the clock

@michaelovitch 5 лет назад

Maybe you can help me : I have a digital clock in my 1990 car,and it's unable to keep the hour i set on it. During the night,looks like it's resetting itself and restarting later on. What could do that ? the battery is good on the car.

@AutomotiveCircuitSolutions 5 лет назад

Did you check all your fuses? It sounds like your keep alive circuit is dead.

@michaelovitch 5 лет назад

@@AutomotiveCircuitSolutions It's an old car,there is no "keep alive" fuse system. I just have a fuse for both the clock and dome lightbulb together,and the clock is working,it's just unable to stay to the correct time. Maybe it's sensitive to voltage drop during the night or something similar ? I just remember that sometimes it comes alive after the car is started for few minutes and blink ,then switch on correctly without blinking. A capacitor maybe ?

@AutomotiveCircuitSolutions 5 лет назад

@@michaelovitch whats the year make and model? I'll look at a wiring diagram. They should have a keep alive wire or else it will reset with each ignition cycle

@michaelovitch 5 лет назад

@@AutomotiveCircuitSolutions I think you are right. I looked at the wiring diagram on the car's manual,and there are two + wires going to the clock : One straight to it via a plug connector,and one other passing through the ignition key barrel/contactor and the autoradio before going to the clock. Their ground is next to the pedals. I will look tomorrow,maybe the connector is not ok,the ground should be ok,the radio is working. It's a 1990 renault 21 gts 1.7 with analog dashboard,i doubt you have the wiring on this thing. ?

@michaelovitch 5 лет назад

Hi, I fixed it. I re-soldered all connections on the board,and it's working normally now. Looks like it worked,but at a specific moment,certainly with temperature change, it lost power,wich would explain why it worked and didn't so erratically. Thank you for your help.