Тёмный

Trask Performance CheckM8 Vented Transmission Top Cover Harley Davidson M8 Engines 

We Ride 2
Подписаться 1,8 тыс.
Просмотров 4,7 тыс.
50% 1

We install and give our thoughts on the Trask Performance CheckM8 Vented Transmission Top Cover for Harley Davidson M8 Engines on our 2021 Road King Special. If you're experiencing blow by or building up your M8 engine this is what you need.
#weride2
#productreview
#harleydavidsonparts
#motorcycleparts
#blowby
#crankcase
#trask
#traskperformance
#harleyperformance

Опубликовано:

 

7 сен 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 17   
@maddmaxx5384
@maddmaxx5384 Год назад
This was one of the first mods I did for my 2023 street bob. Not an easy installation because of bolt access though but doable like you say. Its a fairly expensive part but it is well made and so far I havnt detected any oil on my air filter.
@WeRide2
@WeRide2 Год назад
I probably should have when I upgraded the exhaust on my Street Bob to have it out of the way.... Did you have to remove your exhaust?
@maddmaxx5384
@maddmaxx5384 Год назад
@@WeRide2 I installed the trask unit with the exhaust off. I was changing out the stock exhaust anyway. I think you could still put it on with the exhaust on the bike. Take off a heat shield and any other small stuff in the way.
@WeRide2
@WeRide2 Год назад
Good to know! Thanks!!!
@mattjad3473
@mattjad3473 9 месяцев назад
I've installed it and routed the hose to the right-side cover just as they said and exactly how you did it. But a few months later I noticed lots of oil fumes under the right-side cover. Does it affect the CheckM8 performance if you reroute the hose to the bottom next the bike lower frame?
@WeRide2
@WeRide2 9 месяцев назад
I think higher is better so you have gravity on your side. I've seen it routed up and between the cylinder heads as well. Check your oil levels to see if it's over filled.
@mattjad3473
@mattjad3473 9 месяцев назад
@@WeRide2 I make sure oil is always 2-3 notches less than full. Also I think the nibble has a valve so oil doesn’t go back. I would rather the fumes go below the frame that’s all.
@WeRide2
@WeRide2 9 месяцев назад
Sounds good.. let us know how it goes if you end up routing it that way.
@mattjad3473
@mattjad3473 9 месяцев назад
Routed to left side next to transmission shifter rode. Looks good and any extra fumes will escape to bottom next to left side of lower frame. I’ll try to send pictures.
@Jerm-the_worm
@Jerm-the_worm Год назад
Great video, how does it work so for , is it worth the money ?
@WeRide2
@WeRide2 Год назад
So far so good. Going to clean the air filter and exhaust and see if they stay cleaner this time. Worth the money in my opinion.
@williamrobles4520
@williamrobles4520 Год назад
Where did you get your custom instrument panel cover
@WeRide2
@WeRide2 Год назад
rebuscustom.com/carbon-parts Great guy to work with. Products are top notch
@paulson9616
@paulson9616 11 дней назад
Any difference before n after?
@WeRide2
@WeRide2 10 дней назад
I would say my pant legs don't get stained with blow by like they used to.
@paulson9616
@paulson9616 10 дней назад
@WeRide2 Besides, your pants get stained. Is there any noticeable performance like crisp torque at low gear?
@WeRide2
@WeRide2 8 дней назад
@@paulson9616 TBH no, nothing noticeable in that regard.
Далее
Will A Guitar Boat Hold My Weight?
00:20
Просмотров 45 млн
Нарвался на сотрудника ФСБ⚡️
01:00