I am not a professional. This video is for entertainment purposes only. I am not sponsored by any company mentioned in this video. I did this install based on my own research and used my own money to purchase the products..
In this video, I finally get the Trick Chassis rear-end installed with the brake lines and disk brakes. I can roll it around again!! now we can move over to getting the engine and transmission installed. Which brake hose? The 9" or the 16"? As always links to the parts I used below. If you have questions please ask!! The torque specs that I called out are from Trick Chassis and Calvert. Always reference the manufacturers recommended torque specs when working on or modifying your vehicle.
Thanks for watching, don't forget to like, comment, and subscribe!!!
Rear End Install Links
Flare brake line to 3an fittings - 2 pack
www.amazon.com...
3" U Bolts
www.amazon.com...
MOOG Leaf Spring Bushing
www.amazon.com...
Russell 16" Brake Hose - 10mm to 3an
www.amazon.com...
Russell 9" Brake Hose - 10mm to 3an
www.summitraci...
3/16" Steel Brake Line from O Reilly - I used 2
Part Number PA-330
3/16" insulated clamps that I used on the rear-end to secure the brake line - You can buy these separately at Lowe's
www.amazon.com...
Russell Brake Line Mounting Brackets
www.summitraci...
Clips that hold brake fittings in the brackets - Pack of 4
www.summitraci...
FelPro 9" Center Section Gasket - Part Number 55074
Permatex Oil Resistant Silicone Sealant - Part Number 75190
Lucas 80W-90 Gear Oil - 1 Gallon
www.amazon.com...
CalTracs S10 NOT THE LOW PROFILE - Summit
www.summitraci...
29 авг 2024
