Turn the relay on and off using just one push button 

I can't thank you enough for this little project. It helped me complete fixing a bluetooth speaker. I used your circuit to make an On Off button. Very useful! Thank you again.

I am satisfied with your work 👍 👍🔥

Good work

نعم.

Don't try this because when the 12v supply charges and discharge according to that the circuit switch on and off it is sooo unuseful but i find the solution by modifying the circuit

jika mengunakan relay 5v dan input 5v apakah harus merubah ukuran komponen. dan berapa ukurannya

Jika menggunakan tegangan 24v, apakah hanya merubah relay menjadi 24v saja?

Your circuit is very good and useful. I want to replace the push switch to a touch plate. If I touch the touch plate the circuit will work or not. Secondly Can I use 220v ac capicitor drop supply to make 12v dc to give to the circuit. Thirdly can I use triac instead of relay. If yes than please show me the connection to fix the triac. Anil Kumar Goel

I'm watching from Russia. Well done author! Respect! Made simply and reliably! But, there should always be a scheme! Preferably posted separately or in the video itself, at least for 4-5 seconds. Then it will be considered a full-time job, and this is already professional and high-quality! And you will want to watch something else on this channel! . And with regard to the circuit itself: the author, is it possible to make switching on the most common triac instead of a mechanical relay? For example, the triac BTA41-600; BT136-600 Then it will be much better and more reliable. //// Смотрю из России. Автор молодец! Респект! Сделано просто и надёжно! Но, всегда должна быть схема! Желательно отдельно выложенная или в самом ролике, хотя бы на 4-5 секунд. Тогда это будет считаться полной работой, а это уже профессионально и качественно! И захочется ещё что-то смотреть на этом канале! . И касаемо самой схемы: автор, а можно ли вместо механического реле, сделать коммутацию на самом распространённом симисторе? Например симистор BTA41-600; BT136-600. Тогда это будет намного лучше и надёжнее.

Is there a way to make the circuit start to turn off?...when I energize it it starts with the relay activated and I would like to avoid that. thanks!

Hi, do you think this could work for a one push on, one push off main/low beam headlight stalk on a 12v car? I have been looking for a way to utilise the existing indicator and main beam flash stalk without the current linbus wiring. 👍

هل ستعمل معه 21V ؟ معه اعتبار تغيير ريلي الي 24v بدل 12v

Tem como substituir o botão por um sensor incrível?

Can i use 5 v relay and 5 volt supply?

Tidak berfungsi brother..relay hanya bunyi cetek2.. resistor 15k dah coba ganti 10k..

How dare you call negative ground

Ótimo?

Jak zrobić ten układ działający na 5v ? Z góry dziękuję.

kalo mau buat tombol pushOn yang 2 mode bagiamana kak?

Promo sm 😉

Tipe transistornya apa

Does it use any current when the button is not pressed? Does it keep latched if 12v is removed and re-applied?