Repair Manual:
Micra K12 steering wheel lock falls too early.
The nose I have made of brass 3 * 10 * xmm.
One needs vice, measuring gauge, key file set and a triangular file cut 2. Then about 1.5 hours and as a loan 2 pieces have been manufactured. With me was the first attempt for the Schrotthändler ;-) whereby with so little brass is not synonymous from ...
I used with nem coffee also 1.5 hours and am not a metaler ... :-)
Otherwise, the little locksmith from next-door questions. Perhaps also precision mechanics, dental technicians, watchmaking ... For the last 2 is the rough mechanics :-)
The screws that hold the lock must be sawn off ...
So: Have Nasen manufactured. If necessary please report under florian point bunjes eth gmail point com.
The noses are CNC machined as far as it goes.
Greeting Flo
Question of someone:
Is not it dangerous with self-made parts while driving?
Sure it is dangerous with self-made parts ... :-)
This always depends on where you see it.
The right twist of the Nissan Group we would definitely call it dangerous ...
But if you look at what can happen in the place:
It would in the worst case the Lenkredschloss as the same as the Tüv now complained ...
You should be clear about the connections and you should check what is happening. Otherwise you buy Nissan rather the installation of a whole castle ...
I can not guarantee installation, because I am not at the installation in it and can check whether it works with your lock 100% exactly like this.
Flo
22 авг 2024