Finally I have a working version of the electric angled ATV snow plow! Forget about the other versions and use this as a template if you are building your own for next winter.
Thanks! The trip to you is a bit far (and wet!) but I have cleared my neighbors driveway a couple of times. If I was closer I would help for sure! Best regards Nils in Sweden.
Hey Nils it works awesome good idea using shrink tubing on the ends of the cables . so I just got the notification of your video this afternoon . Thanks for sharing my video I just took off my plow so probably will snow again soon here .
It may cause less stress if your winch cables run straight out/forward to the back of the plow where the cables 90 degree turn out to the edge’s through a small pulley (one for each cable). At the outer ends of plow, they run 45 degrees back towards the centerline of the ATV again to anchor. Cables form two right triangles back to back through 2 pulleys each.
Hey Nils , is the cable on the your left on the blade , is it a short cable that is tied off on both ends ? Does it just get its tension from the spring being stretched out ?
Hi, might not understand the question but the cable is shortened and both ends are just tied of. It attaches to both sides of the plow and the short springs are there for tension because it just slipped on the drum without them. I think it is easier to se in the first video I made about this snowplow? Building a power angled ATV snow plow ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-4MEGg41qSys.html
Thanks Nils . I watched the 1st video & now I see you loosened the cable . Rewound it around the spool & reversed how it came out of the spool ? Is that correct ?
@@danbradley8052 yes! It pulls one end and slackens the other. But the thin cable wasn’t strong enough to hold for sudden jerks. The version in this video seems to work well. Except that the electric motor of the winch rusted due to water inside it…
Stop snowing? Actually we had the first really warm day today, spring is just around the corner. I won’t plow any more snow this season but I still have some older videos to edit and publish.
Hade du ställt vinschen rätt upp å ner hade du sluppit alla linblock och vinklar i wiren,har klurat på samma ide själv men fick tag på en belos transpro 1500 med hydrauliskt klaffblad,fjädrarna är nog väldigt viktiga,dom räddar nog mycket vid ett hugg i bladet
Ja det stämmer men då hade inte vinchen fått plats när man höjer plogen. Om man har en undermonterad plog eller längre avstånd mellan plog och maskin så skulle det vara en bra ide. Belos är fina grejer! Mycket kraftigare än alla ATV prylar!
Problemet med plogning med fyrhjuling utan bandsats är ju att det är svårare att göra nå vettiga snöhögar så platsen för snön räcker hela vintern. Jag brukar få ta slungan å köra bort det ibland så jag kan ploga dit nytt.
@@NilsKall jo så är det ju. Min arbetsgivare brukar komma förbi med L70:in när det blir riktigt mycket. Som mest tror jag vi fick runt 30-35cm på en gång nu i vinter å plogkarmen blev ju det dubbla ungefär. Då fick quadrunnern jobba lite 🤣👍