My bottom gantry system isn't working... I tried to rebuild it but it is not moving of an inch. Do you know why ? On my creative world, it worked. Thanks
I built this and the silverfish arent spawning / infested stone isnt being placed, my gantry at the bottom is running at 89 rpm and the deployers are making the sound of placing infested stone and doing the animation, however it wont place, im not sure whats wrong.
Hello, I just used your schematic today. What's the required rotational speed for the silverfish to spawn? A bit of a problem I had was that the haunted stone isn't seen to be (or maybe its too fast to be seen) dropping into the conveyor belt and spawning in silverfish. Could it be that the machine is overflowed? About 10 silverfish spawned in those two times but I didn't shut the machine off - and then there are no more silverfish spawning. I tried flicking the machine off and on again, but silverfish aren't spawning anymore. Should I wait ? How can I make the machine spawn in more silverfish and make it last a longer time? If that's the issue.
Deployers will place down silverfish, the discplacement gantry needs to be rotating above 50 for it to run at an appropriate speed, look at the Rotation Speed Controller at the bottom connected to the gantry.
I may be dumb but for some reason when i turn everything on the water at the top goes spilling everywhere. I built the machine with schematicannon and then put the water and lava everywhere it needed to go as well as editing the threshold stuff. i am currently just using a ton of large water wheels which only is allowing me for about 32 rpm so im wondering if it has something to do with e speed? also, a lever and a redstone torch were found found at the bottom after all the water came down and i have no idea where they were before hand. any help would be appreciated lol.
Yes, your assumption is correct. The Cobblestone Generation method at the top requires a higher RPM before it can function without causing water to fall out. And the Lever and Redstone link were probably placed on the clutch :) Hope that helped.
Make sure that you only plugged power into the Clutch at the top of the creation, if you did, flip the rotating direction of the Rotation Speed Controller
@@littlemonster4425 A gearshift. Make sure its in the contraption. it doesn't supply its own rotational force so if its at the edge of an contraption and not IN it, the gearshift wont work
Hmm, that shouldn't be happening. Make sure that you only have power being sent into the clutch at the very top of the machine, if it's routed at any other point it will not function.
All rotational directions should be managed by the speed controllers so this will be unnecessary, if you are on a different version from when this was made then the speed controllers might be bugged, if so, just reverse the set directions to the negative or positive value
@@lalanecek5979 the link to the schematic is in the 'creator' comment of the video... But here's the link. createmod.com/schematics/ultimate-experience-farm-30-levels-in-15-seconds
