Ultimate Guide - RP2040 Nintendo Switch OLED Install Visit us online at: Wayayeo.org Like and subscribe if you like this video. EDUCATIONAL PURPOSES ONLY
I hate to be that person, but what are you installing on the board? I’m pretty sure it’s some kind of bypass or a common issue on these Oled’s, but I haven’t worked on any thus far, but would love to know what issues this resolves with them Thank you
You’re welcome. Microscope is a Leica. Camera is an Eakins. I have tried a few others and pretty much any $300 and up look the same. Got it on aliexpress, no model #.
12:48 Do cover the inner side of the nand shield with kapton tape. The solder blob will touch the shield (grounding it) at some point in time if the console is dropped or shaken. Happened to me once.
@@WayayeoI have an smd soldering station hot air + stylo can reach 900 F. I ask this because I planned to mod my Switch v2 and dont want to overheat the pcb.
Hello, thank you very much for everything you do I have a problem the device boots directly to the base system and does not enter the modified system The shape of the flashes of the LED lamp is as follows : ru-vid.comO8dwRjmyKEs?si=zaDRE-_ccsvqzlR_ Can you help me solve this problem? Thank you very much
I have this exact problem where it flashes blue followed by 2 yellows 3 times I checked all the connections are made perfectly no shortage either All the values appears to be ok on continuity any advise???
@@GameOn-li6qe In my case I think the problem is in point C As far as I know, the value should be between 0.6 and 0.7 For me, the color of the flash is blue and green maybe your problem is modchip firmware, i wish you find a solution