I was close to by these things, thanks for showing. Thought they are working under the water, not at the water level. Due to this, these foggers are not useful for my project. Thanks a lot.
I’ve had mine in continuous operation for 4 months now, I just make sure to clean the disk -gently- with every refill Looking for any limescale or hard mineral deposits building up on the working side of disk. Many people think the disk is dead when it only is in need of good cleaning by gentle, and I mean gently -I cannot stress this point enough, with a pointed object small enough to chip deposits off. You could also use vinegar water soluble to help loosed and dissolve mineral build up. Done successfully it will work exactly as nex
Mine was working fine then suddenly stopped. is there is a possibility of any damage within the circuit as i guess the current is not flowing through. how could i fix it or check it what is happened inside. mine is a bulb humidifier.
Same for me, stopped working. Some family members had a similar device to look like smoke in an electric fire but these also fail after a bit of use. Note kept wet all the time as we must. So junk
I want to spray the water mist to little longer distance , so how to do it ? Can i boost the piezo electirc disc by transistors ? Or can i get little long distance by buying big disc than before ? Plz clarify 🙂 i am currently involved in project , plz help me ❤
@@LEO-xo9cz One way is to manage things with a micro-controller (What Arduino runs). You can have a sensor, like a switch on a float that tell the circuit to shut off (multiple sensors may solve the same issue interchangeably, float is just one idea.). You could try to make some mechanical shut off, again maybe with a float, so that when the water level falls, the circuit is broken. This is simpler that a micro-controller if you don't know how to use one, but would be more difficult to tune/configure so it's reliable. Depending on how often you are checking on the device, you could just have a large reservoir ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-mz5r_pRKjuM.html. I plan to use this design since I'll be checking my device periodically, so I can easily refill. This setup will maintain a (roughly, if the falling momentum doesn't push out a little extra) constant water level. You can combine these methods.
I think there are some for electric fires that pretend to be smoke, to make the fire look more real; I think these have a switch to stop burn out is they run dry
Sorry I don't know, but ultrasonics is said to be bad on the body, but some used for pregnancy, etc... www.researchgate.net/post/Do_ultrasonic_waves_have_any_negative_impact_on_humans2
Get a power supply from some christmas lights or a phone charger cable. Make sure the output voltage (DC) is between 3v and 12v for this board. Change the end of the of the cable to match the input for the board and that's it
