Brilliant... my ppks was doing the exact same thing with the canister tipping forward and gas just instantlyleaking... plastic had broken as well around the base as I had dropped it once.... never thought of looking at the metal frame flaring out.. it is being repaired under warranty at the minute.. wonder if they have spotted it .. I saw in some photos that inside the valve there is a metal sponge-like filter and if removed will give the gun more oomph...
Hi Anthony apologies for the late reply I’ve only just seen this it was a head scratcher at first I’ve managed to straighten the frame and I’m currently making a metal replacement for the plastic base cover that broke hopefully will have it sorted and a video up soon fingers crossed your one gets repaired and is back with you soon buddy 😁
Hello sorry for the late reply I have been out of action for some time. You can try a few drops of pellgun oil on the seals. I would then check that the frame hasn't bent open like mine from the previous owner over tightening the bulb pusher. If still leaking I would then replace the valve seals and o-rings. Make sure the o-rings are suitable for co2 Hope you get it fixed buddy 👍
Hello sorry for the late reply I have been out of action for some time. Thanks for the useful information buddy I will sort a mic for upcoming videos and if possible record new audio over this one 😀 👍
Hello buddy Many thanks I appreciate it my next video will be on 3 different types of 1911s as suggested by another viewer as they all have different mechanisms
@@bingobango7734 FANTASTIC :) !!! Thanks you so much. + here a photo mod you can do for your walther ppks to look more like the real firearms : (I can provide online photo in private message but the website link are erased my youtube. The maker mention : " The PPK and the PPK/S are two different guns. But the PPK/S (which the replica is based on) is basically a Walther PP frame with a PPK slide which was done for some U.S requirement. I had the CO2 replica which I modded. Since it's a PP frame I was able to purchase reproduction PP grips and fitted them on to the air pistol which was a nightmare of a task with aligning the spring clip. I also chopped off the rear bottom corner of frame to make the extended magazine stand out more. To me it looks much better than the stock version."
@@bingobango7734 if you can only have one get the KWC 1911 (made by cybergun) from what i can see online all the modern Colt 1911 co2 are build the same (KWC , Gletcher , Tanfoglio witness 1911 etc ) but im dont own them (just the KWC) and im not a specialist...
Hello Have you completely disassembled it cleaned and lubed everything ? Sometimes a good clean and lubrication is all that's needed. Next check the front plastic barrel retaining pin is the correct one for example if you stripped it all down for cleaning did you fit the correct pins if it's a thinner one it could be slipping out and jamming the top slide also check that the hole isn't warped can you wiggle that barrel section ? Next check the silver trigger bar on the right is it all sitting flush and moving freely make sure as you pull the trigger nothing is causing it to kick out. I would also check the top slide it's possible the top slide may have been squeezed in and bent a little.
