The soundtrack is "Gymnopedie No. 1" by Kevin MacLeod (incompetech.com). Yes, I know I didn't show the final drop- I had to assist in locating the exact drop spot, and stopped my impromptu recording of the whole event. Sorry!
I stopped the video at that point because I had to run and grab some "cribbing" (large blocks of wood) to place temporarily under the bottom side rails of the container, a couple of meters from the end. I stack them high enough to place the container end somewhat higher than level. Then I build up a gravel base under the corner boxes of the "hovering" end of the container, and lay a railroad tie between the gravel and container, gradually lowering the container with a hydraulic jack until it sits level on the railroad tie ("crosstie" in some other countries). In cases where I'm placing a container temporarily, I will have the driver pull the trailer nearly out from under, then place a RR tie right on the ground under the corner boxes. The back edge of the trailer is tipped down until it's JUST over the RR tie, then the driver moves forward, dropping the container more or less right on the tie.
I stopped the video at that point because I had to run and grab some "cribbing" (large blocks of wood) to place temporarily under the bottom side rails of the container, a couple of meters from the end. I stack them high enough to place the container end somewhat higher than level. Then I build up a gravel base under the corner boxes of the "hovering" end of the container, and lay a railroad tie between the gravel and container, gradually lowering the container with a hydraulic jack until it sits level on the railroad tie ("crosstie" in some other countries). In cases where I'm placing a container temporarily, I will have the driver pull the trailer nearly out from under, then place a RR tie right on the ground under the corner boxes. The back edge of the trailer is tipped down until it's JUST over the RR tie, then the driver moves forward, dropping the container more or less right on the tie.
@@DarronBirgenheier thanks for responding. My husband and I just bought a 40’HC and it’s 8 ft wide but we were worried we may need ties longer than 8 ft. Good to know we can possibly use 8ft ties. Thanks again.
@@DarronBirgenheier IC. Very versatile rig that delivered it. Not sure it would be legal in Australia though.Drive axle loaded weight might be a problem here.
I stopped the video at that point because I had to run and grab some "cribbing" (large blocks of wood) to place temporarily under the bottom side rails of the container, a couple of meters from the end. I stack them high enough to place the container end somewhat higher than level. Then I build up a gravel base under the corner boxes of the "hovering" end of the container, and lay a railroad tie between the gravel and container, gradually lowering the container with a hydraulic jack until it sits level on the railroad tie ("crosstie" in some other countries). In cases where I'm placing a container temporarily, I will have the driver pull the trailer nearly out from under, then place a RR tie right on the ground under the corner boxes. The back edge of the trailer is tipped down until it's JUST over the RR tie, then the driver moves forward, dropping the container more or less right on the tie.
@@DarronBirgenheier Yeah, combined with the tare weight of the trailer i think the drive axle would definitely be overloaded --- in Australia at least. But maybe not. Also here we have a rule that a towing vehicle cannot tow more than 1.5 times its own weight. Used to be 1.0 ( no more than its own weight) but they changed that to allow for new combinations being adopted.
