Mantap mas....bisa di buatin sketsa ukuran serta bahan2 ny mas....maaf, saya pemula bnget, cma kpengen buat seperti it,,,sngat mnginspirasi...trima ksih🙏🙏🙏
Rencana dalam waktu dekat dan tentu aja kalo ada waktunya sy jg mau rubah cs jd ts, tp sy perhatikan mekanisme kemiringan ts abang dirubah, kenapa ya bng? Apa lebih efektif yg ini?
masa allah kreatip benar mas semoga ilmunya bermampaat buat kita semua amin,oh iya mas maap itu tripleknya pake yg berapa mm dan rel hitam panjang berapa mm
om, izin tanya.. gear Bevel pengantar antara handle pemutar dengan as drat pengangkat box pisaunya itu pake gear bevel punya apa ya om..?? trus dapetnya boleh tau dmna y om.. trims infonya om.. sehat n sukses selalu ya om..
Ijin mas mau tanya.. kalo saya pake basic mesin cs maktec saya pasang blade yg 9 inch masih aman gk mas? Soalnya saya pake blade 7 inch hasil akhir keluar blade nya hanya 4.9cm
No disrespect intended but a table saw is only a couple of hundred bucks and are way better than any homage. Also on top of that I'm guessing you spent more building it. Anyway I made my router table because they're way to expensive. So I'm all fore building my own tools if it's more cost effective. Still nice work.
You do have to spend some time setting the saw up... blade, fence, etc. But once done, the saw is great. Fairly compact which is Nice ru-vid.comUgkxXh-4_3-ZT1fFWP91ZV7iVqzElr0lEb-a I did get an Incra Miter Gauge which takes some setup as well. The stock miter gauge can be adjusted in the miter slot with a little painter's tape... this tightens up the side to side play a lot.