Using a Titan middle potato buster for flood control maintenance 

It's not deep enough, even when lowered all the way. After buying it, I later saw in the specs that it's made for 30HP tractors (or less). I have a 47hp. In other words, since my tires are much larger than the tires on a 30HP, it was not low or deep enough (too high), even on the lowest setting. I need a welder to extend the shaft. Then it will do much better.

@@ForensicPI I noticed that the shaft was short on this one. I actually have three of these (two were inherited), one of which I bought. The exception is that I bought the sub-soiler with the longer shaft and a separate spade blade to put on it. That thing will dig some ditches. I put in "cross ditches" where the water runs just to slow it down, but also runoff ditches that carries the water completely off the field. I found that I can run it in hard ground and cut a ditch about 4 inches deep and then go back over it to cut out another three or four inches. It works great. In my field where there is softer dirt I can drop it while moving and it will sink down 7 or 8 inches and throw that dirt up and out. I personally like the sub-soiler better for water management, but for ditches this middle plow works great.