I have this set up on my Big Block Chevy that has lots of blow by and it works perfect. However, I have cast aluminum valve covers from Chevy HP and found the o-ring seal didn't work that well so I had to add some silicone to get it perfect. Thanks for solving my leaks MRW.
Currently working on figuring out what all I need to build a hybrid 16v turbo Volkswagen engine and they tend to have high crankcase pressure, the breather on the block isn't enough. Trying to figure out how to vent the valve cover in a way that doesn't look out of place lol, best option right now is to weld an AN fitting on the end of it. If this fits it might be a better solution.
hey brother im rob from australia, i have an alloy fsbricated valve covers on my small block chrysler. they have a breather hole in each one, about an inch. will you breathers cover that? thanks
Just ordered a set for my supercharged fox, my trickflow valve covers arent baffled and the catch can was filling up way too fast. Hope this takes care of the problem.
@@MotionRaceworksOfficial So are these big enough to cover the standard hole in the SBF valve covers? I can measure my holes if you can provide the measurements of the template. I just bought a Vibrant dual 10an can and want to run a 10an from each valve cover. And stop these leaks from those big rubber grommets. I think they are 1" or so?