VarmdoScooter ZX Engine Renovation Ep.4 new crank bearings
Putting in new crank bearings and crankshaft and oil seals
Short summary.
In November 2022 I bought a Kymco ZX from a girl who lived in Saltarö, Värmdö. According to her statement, only the gas wire was faulty. So I thought I'd take the plunge and hit the ground running.
However, it turned out to be much more of a problem than the gas wire. The engine had no compression, the oil pump was broken, and there appeared to be a large scratch in the cylinder. I also noticed that the air filter box was not connected correctly, so probably a lot of crap got in as she lives near the beach and sand and dirty dirt roads.
So this is the story of how I restore this engine. In this section I will attempt to fit new frame bearings using heat and cold. Stay tuned and we'll see how it goes!
----------- In Swedish ------- Kort sammanfattning.
I november 2022 köpte jag en Kymco ZX från en tjej som bodde på Saltarö, Värmdö. Enligt utsago var det fel på bara gaswiren. Så jag tyckte jag gjorde ett kap och slog till.
Det visade sig dock vara betydligt mer problem än gaswiren. Motorn hade ingen kompression, oljepumpen var sönder, och det visade sig vara en stor repa i cylindern. Jag noterade också att luftfilterboxen inte satt rätt kopplad så antagligen har det kommit in massa skit då hon bor nära strand och sand samt skitiga grusvägar. Så det här är historian om hur jag renoverar denna motor. I det här avsnittet ska jag försöka montera nya ramlager med hjälp av värme och kyla. Häng med så får vi se hur det går!
14 дек 2023