thank you Sir! I have done this today 100% identical , including the "resistor box". my sensor is open circuit, I have both signal + reference 5v, sens. connected. very pleased to see the video , all the best!
I have a 2012 Renault Trafic, the Injection Fault Stop light keeps coming on in intermittently and today struggled to start. Code reader comes up with P0002. Any ideas on where to start? Thanks.
Amazing video. Thats the exact same thing as mine im 100% sure its the sensor but i cant for life of me find a Fuel pressure sensor for a Vivaro CDTI 1.9 53 plate.
Nicely done. Have you ever come across a Renault Traffic 1.9 that starts but wont rev when its warmed up. All of the mechanics I have seen in Devon, including the the dealership cannot diagnose the problem.
2003 vivaro 1.9 confused... just removed wiper stalk looked it over put back van dont start turns over does not fire up glow plug lights do not illuminate checked fuses wiring 70 amp fuse at bonnet checked gloplugs injectors done many checks crank shaft sensor replaced got the voltage like you on the fuel sensor when plugged in i have tried continuity between fuel sensors 3 pins while still in the rail and not had a bleep so would you say its the sensor???? i heard that maybe the solenoid open and close switch on the high fuel pump may be stuck in closed position im lost please help
Why does the voltage drop-disappear when connected? I have a Volvo v70 d5 and every time I connect the fuel pressure control valve to the connector 8v disappears. At first, I thought that the connector wiring was bad but it wasn't. Right now basically when the ignition is turned ON the valve stays shut because there's no voltage when the sensor is plugged in.
I've got a similar problem on my 2005 Trafic 1.9, i'm on my second fuel rail pressure sensor now, the last one said the fuel pressure was incredibly high, despite there being zero pressure and the latest one is only reading 0.38v and drops one cranking... I've just ordered another to see if i've just been unlucky and bought duff sensors; hope so 🥲
I got a 2002 combo 1.7dti.. starts great but if left for a few days or a week it struggles to start it will start eventually after pumping the throttle pedal... could this be the fuel rail sensor????
hi got the same with my vivao 2002 1.9 is there a part number as i have got problems trying to find one all coming up renault but not compatible with my van many thanks
Hello I’ve got a similar fault with my 2004 Renault trafic 1.9 van will turn over but not fire up then engine stop light starts flashing watched your video and tested fuel pressure rail sensor connector and loom but not getting any voltage with it disconnected is it likely to be the ecu faulty? Many thanks
Check to see if there is voltage at the ecu on the feed. Have you also confirmed the earth on the sensor? This will also give you chance to check continuity of the wires. Thanks for the comment👍
Help. Cranking but want start No lights abnormal on dash. Alarm light goes out. half tank of fuel. last used 3days earlier with no problem. Good battery + used booster pack. Any ideas will be appreciated Oops !! must add vivaro 04 year
Got a strange one, got p1822-0a fuel pressure solonoid valve circuit low input (getting 8v) and p0191/p1882-09 fuel rail pressure sensor range/performance. The pump solonoid has a very submit buzz when the ignition is turned on. P1885-0d replace control unit P1826-0b how device circuit general error. Van cut out and won't restart on its own but will start and idle if you stand pumping the primer bulb on the fuel filter.