Hi! this is a small sensor capable of detecting vibrations and going in alarm turning on the LED. The two main components of this project are a NE555 and a Vibration Switch. The operation is very simple, when the vibration switch detects a vibration, the NE555 PIN 2 is sent to ground making the LED ON. The reset button returns the circuit to the initial state.
A vibration switch is a simple protection device that senses vibration and triggers an alarm. Inside there is a spring that in the presence of vibrations oscillates and hits the metal wall, closing the circuit and allowing the passage of voltage.
Components:
1x NE555 IC
1x LED 5mm
1x 300 Ohm Resistor
1x Button
1x Vibration Switch
Power with 5-9 volt DC
Circuit Diagram at: 1:36
0:00 - Intro
0:13 - Explanation
0:36 - Test
1:36 - Circuit Diagram
1:43 - End
■▬▬▬▬▬ LINK & Support ▬▬▬▬▬■
✅ RU-vid: / stefano91ste
✅ Instagram: / stefano91ste
✅ Pinterest: www.pinterest.it/Stefano91ste
✅ My STORE: / stefano91ste
Watch another video =)
● Music Keyboard: • Music Keyboard with NE...
● LED Water Level: • LED Water Level indica...
● Police Light: • POLICE LED Light DIY w...
● Vu-Meter Stereo: • Vu-Meter Stereo -20 +3...
● Traffic Light: • Make your own Traffic ...
● Vu-Meter 40 LED: • Vu-Meter 40 LED on PCB...
● Voltage Detector: • VOLTAGE Detector DIY -...
WARNING: This video is only for demonstration. I don't take any responsibility.
Music: Fast and Run - Nico Staf
#ne555 #electronics #diyprojects
23 июл 2024