Volkswagen Polo 9n3 | Xenon HID Headlight projector Upgrade installation DIY 

Hi, Unfortunately, that will not fit at least not with major modifications. We do not have a 3 inch kit for it.

Thanks for your questions! :) Please send an email to info@retrofitlab.com so we can give you personal advice. :)

Hi, we have upgrade kit only for halogen headlight (original current headlight), if your headlight is Halogen, you can visit this link retrofitlab.com/collections/volkswagen-polo-9n

There is no need to remove the entire bumper, however, you will have to unscrew some bumper screws to make a little space for the headlight to come out. There are several video's online that will show you how this can be done.

***** Heb je misschien iets van advies, of een handleiding, hoe ik dit het beste kan aanpakken? Ik zat al te kijken voor tweedehands Bosch koplampen, maar die zoektocht heeft nog niets opgeleverd helaas.

okay then, good job anyway (y)

Okai thank's :D

Retrofitlab Thank YOU ! I am about to Open the lighthouse and buy the bi-xenon , very explicit video ! Best regards !

Thanks!!

In The Netherlands, it's not an easy retrofit, but with some patience it is definitely doable :-) retrofitlab.com/collections/volkswagen-polo-9n

Without heat it's not an option. In general, 2 methods are used, with both methods, be careful and patient. Method 1 is using a regular oven. Preheat the oven at 200 degrees Celsius. When ready, switch off the oven and place the headlight inside. Make sure that the headlight is not touching any metal of the oven by placing a cloth over the grid, for example. Leave the headlight in the oven for 10-15 minutes before opening it. If the headlight kit is not yet soft enough, put the headlight in the oven for a bit more time. Method 2 is suitable for larger headlights that do not fit in a regular oven, or if your lovely wife absolutely does not allow car parts to be baked in her kitchen. A large cardboard box is used where hot air is blown through a heatgun. Make sure that the hot air of the heatgun does not blow directly to the headlight, place the headlight on small elevations so that the air can circulate properly through the box. We use a setting of 300 Degrees Celsius for 12-18 minutes / 1st lowest setting, depending on the size of the headlight.

Retrofitlab.com hi thanks for the reply, how do I ensure that the projector is actually positioned the right way up so I don’t have an upside down or wonky beam pattern?

@@Zeebean384 When you have the projectors it will be quite easy. There is writing on them, the solenoid needs to be at the bottom and the mounting rings only fit one way.

Because of the small reflector and H7 base, a 2,5" projector

=)))

anyway...now i'm waiting for a clio owner, to send his lights to Retrofitlab =)))

thanks ;) good work

Eww

***** Thanks for your reply. Do you know if i need something with that for my retrofit ? www.retrofitlab.com/en/xenon-projectors-1/mini-h1-bi-xenon-projectors-60-1.html