#VRS#
virtual reference station#
To reach centimeter-level - or even better - accuracy of positioning typically requires use of precise dual-frequency carrier phase observations. Furthermore, these observations are usually processed using a differential GNSS (DGNSS) algorithm, such as real time kinematic (RTK) or post-processing (PP). Regardless of the specific differential algorithm, however, implicit in the process is an assumption that the quality of the reference station data is consistent with the desired level of positioning accuracy.
The virtual reference station (VRS) concept can help to satisfy this requirement using a network of reference stations. As a quick review, a typical DGNSS setup consists of a single reference station from which the raw data (or corrections) are sent to the rover receiver (i.e., the user). The user then forms the carrier phase differences (or corrects their raw data) and performs the data processing using the differential corrections.
In contrast, GNSS network architectures often make use of multiple reference stations. This approach allows a more precise modeling of distance-dependent systematic errors principally caused by ionospheric and tropospheric refractions, and satellite orbit errors. More specifically, a GNSS network decreases the dependence of the error budget on the distance of nearest antenna.
At the same time the rover calculates its approximate position and transmits this information to the computation server, for example, via GSM or GPRS using a standard National Marine Electronics Association (NMEA) format. The computation center generates in real time a virtual reference station at or near the initial rover position. This is done by geometrically translating the pseudorange and carrier phase data from the closest reference station to the virtual location and then adding the interpolated errors from the network error models.
This generated VRS data is then sent to the user through a wireless connection, often using the Networked Transport of RTCM via Internet Protocol (NTRIP). Finally, just as if the VRS data had come from a physical reference station, the rover receiver uses standard single-baseline algorithms to determine the coordinates of the user’s receiver, in near-real-time kinematic or post-processed modes.
The main purpose of a VRS station is to reduce the baseline distance between the rover and the reference station in order to efficiently remove spatially correlated errors using differential processing, and to incorporate error corrections obtained from the reference stations network.
To this end, the position of the VRS plays a critical role. In particular, because the user receiver cannot, by design, distinguish a real reference station and a VRS, the distance of the VRS from the user must be commensurate with the level of errors present in the VRS data. This is what allows the receiver to use its standard data processing algorithms, which vary as a function of the baseline length (i.e., distance) to the reference station.
Now, imagine if the errors in the VRS data were similar to a 20-kilometer baseline, but the VRS position was situated only 2 kilometers from the user. In this case, the user’s receiver would attempt to use L1-only processing, but the level of errors in the data would almost certainly not allow reliable results using this approach.
From this example we can see that the VRS concept basically needs the resource of a physical GNSS network surrounding the measurement area of the rover, with a minimum of three reference stations to enable the modeling of errors.themselves must be installed over stable sites, preferably distributed homogeneously over the operational area. If possible, the antennas must be fixed in bedrock to ensure long term stability of the receiver’s position.
Using the VRS technique, highly improved RTK positioning can be performed inside the network area. The precision of RTK positioning using VRS reaches two centimeters in the horizontal plane and four centimeters in the vertical direction (2σ).
The VRS concept allows a less dense antenna network without accuracy degradation because the multiple reference station network better models the spatially correlated GNSS errors over longer baselines. As a result the maximum distance between the rover and the nearest reference station can be extended in comparison with the typical 10 ~15 kilometers without accuracy degradation of the single reference station case.
A VRS service uses data from several (permanent) reference stations to compute corrections that are generally more accurate than corrections from a single reference station. These corrections are then broadcast over the Internet.
9 сен 2024
