Thank you for the tutorial video. Question; does the original mileage of the vehicle display correctly on the cluster from another vehicle and where is your garage?
@@ashezplayboy you need vag commander software. but first open vcds software, go to settings and uncheck intelligent mode, click save. then open commander software, press on dash/cluster, then press read eeprom. you'll see pin code at the bottom. when you want to program key, go to vcds, instrument, login enter pincode (for example if your pin is 1234, enter 01234. type 0 in front of your pin) then go to adaption, enter group 21. and select number of keys you want to program, click save, turn off ignition, and turn on ignition again. your key is programmed
Ja som dal nakodovat v AutoRotos. Ale neoriginalny kluc nesiel nakodovat. Tak som rovno musel cez nich objednat original. Nakodovali to za 20 euro. Len ten originalny kluc stal 160 euro.
Týmto spôsobom sa dá zistiť login aj do ostatných jednotiek?mám touareg a nemám loginy aby som si mohol niektoré veci poriešiť, okrem adapt vzduchoveho podvozku,tam login uz mam
@@shaagealgareb9189 the color code is printed on a sticker that is somewhere on your car. Check spare tire wheel well, engine bay, left B pillar etc. Should look similar to this: LY7W
Did you install the drivers? Theyre old, so i had to disconnect from wifi, turn off mcafee and install thru control panel cuz they're from Win7 and anything older than windows 10 is instaflagged as a virus. (Edit I did a virus scan after install and it was clean)
@@insus100 Oh dang, could you upload the software to a google drive folder please(or anywhere else that I could download it from)? I don't want to buy another cable only for this one time use :/
